Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4170W
$14.99
(You save)
Keep the front stabilizer bar located and quiet with the Delphi Suspension Stabilizer Bar Bushing Kit (TD4170W). These bushings cushion the stabilizer bar where it clamps front-to-frame, isolating it from the chassis and helping control body roll through turns. This kit is a direct-fit replacement for the 2001-2010 Chrysler PT Cruiser, 1995-2005 Dodge Neon, and 2003-2005 Dodge SX 2.0 — see the Buyer's Guide tab for engine-level details on your vehicle.
Designed to OE standards: Delphi applies its OE engineering experience to its aftermarket steering and suspension portfolio, with extensive dimensional and material analysis for close compatibility between the OE and aftermarket part.
Tested to the extreme: validated below -40°C and over 120°C and exposed to 720 hours of salt spray for OE-level performance.
Built for consistent life: manufactured for consistent service life and to reduce noise.
Smoother ride: designed to help restore the vehicle's smooth ride when worn bushings are the cause of clunks or rattles.
Also listed as a stabilizer bar bushing kit. If cracked, worn, or noisy front-to-frame bushings are behind a clunk or rattle over the road, this kit replaces them.
It supplies the cushioning bushings that mount the stabilizer (sway) bar to the frame. They isolate the bar from the chassis and help control body roll while limiting noise and movement.
Which vehicles does the Delphi TD4170W fit?
It is a direct-fit replacement for the 2001-2010 Chrysler PT Cruiser, 1995-2005 Dodge Neon, and 2003-2005 Dodge SX 2.0. Check the Buyer's Guide tab to confirm the fit for your vehicle.
Where do these bushings mount?
This kit is cataloged for the front-to-frame position, cushioning the stabilizer bar where it clamps to the frame.
What are signs these bushings may need replacing?
Worn or cracked bar bushings can cause clunks, rattles, or squeaks over bumps and looser handling. Diagnose the cause first, since other suspension parts can produce similar symptoms.
What numbers does the TD4170W cross-reference?
It interchanges with 5272646AA, BSK81280, BSK81280PR, K80365, GK80365, MK80365, and JBU1140.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4170W
Quiet a clunking rear sway bar and keep it located under hard cornering with the Delphi Suspension Stabilizer Bar Bushing Kit (P/N: TD4177W). This kit cushions the rear stabilizer bar where it mounts...
Keep the rear stabilizer bar located and quiet with the Delphi Suspension Stabilizer Bar Bushing Kit (TD5070W). These bushings secure the rear stabilizer bar to the frame, cushioning it against the...
Quiet a clunking, rattling front sway bar and help keep your Mercedes-Benz cornering flat with the Delphi Suspension Stabilizer Bar Bushing Kit TD5885W. This front-to-frame stabilizer bar bushing kit...
Quiet a clunking front sway bar and keep the stabilizer bar located where it belongs with the Delphi Suspension Stabilizer Bar Bushing Kit TD671W. These front stabilizer bar bushings cushion the bar...
Quiet a clunking front sway bar and keep the stabilizer bar properly located with the Delphi Suspension Stabilizer Bar Bushing Kit (TD994W). It drops in as a direct-fit replacement for the front...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
