Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4187W
$18.99
(You save)
Quiet the clunks and firm up body roll with the Delphi Suspension Stabilizer Bar Bushing Kit (TD4187W). It drops in as a direct-fit replacement for the 2009-2013 Ford F-150, mounting in the front stabilizer-bar-to-frame position to locate the bar and cushion it against the frame. As these bushings wear or crack, the stabilizer bar can shift and knock, so this kit restores the correct clamp and helps the bar do its job of limiting body lean through turns.
Designed to OE standards: Delphi builds this kit to OE standards, drawing on the OE safety technology fitted to millions of vehicles worldwide.
Tested to the extreme: validated for OE performance below -40°C and above 120°C and through 720 hours of salt spray, with extensive dimensional and material analysis for OE-to-aftermarket compatibility.
Built for consistent life: manufactured for consistent service life and to reduce noise.
Smoother ride: designed to help restore the smooth ride of the vehicle.
This stabilizer bar bushing kit is a straightforward wear-item replacement when the originals have hardened, cracked, or gone noisy. See the Buyer's Guide tab for the full application list and engine details.
What vehicle does the Delphi TD4187W bushing kit fit?
It is a direct-fit replacement for the 2009-2013 Ford F-150. Check the Buyer's Guide tab to confirm the fit and engine details for your specific truck.
Where does this kit mount on the truck?
These are the front stabilizer-bar-to-frame bushings, so they clamp the sway bar to the frame and cushion it against noise and movement.
Is this the same as a stabilizer bar bushing kit?
Yes. "Sway bar bushing kit" and "stabilizer bar bushing kit" are two names for the same part, and both refer to this Delphi TD4187W.
What are signs these bushings may need replacing?
Worn or cracked stabilizer-bar bushings often cause clunking or rattling from the front over bumps or through turns, plus increased body roll. Diagnose the source before replacing.
How was this Delphi bushing kit tested?
Delphi validates it for OE performance below -40°C and above 120°C and through 720 hours of salt spray, with dimensional and material analysis for OE compatibility.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4187W
Quiet a clunking rear sway bar and keep it located under hard cornering with the Delphi Suspension Stabilizer Bar Bushing Kit (P/N: TD4177W). This kit cushions the rear stabilizer bar where it mounts...
Keep the rear stabilizer bar located and quiet with the Delphi Suspension Stabilizer Bar Bushing Kit (TD5070W). These bushings secure the rear stabilizer bar to the frame, cushioning it against the...
Quiet a clunking, knocking rear sway bar and keep the stabilizer bar located properly with the Delphi Suspension Stabilizer Bar Bushing Kit (TD996W). This rear sway bar bushing kit cushions the bar...
Quiet a clunking, rattling front sway bar and help keep your Mercedes-Benz cornering flat with the Delphi Suspension Stabilizer Bar Bushing Kit TD5885W. This front-to-frame stabilizer bar bushing kit...
Quiet a clunking front sway bar and keep the stabilizer bar located where it belongs with the Delphi Suspension Stabilizer Bar Bushing Kit TD671W. These front stabilizer bar bushings cushion the bar...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
