Quiet a rattling sway bar and keep the stabilizer working the way it should with the Delphi Suspension Stabilizer Bar Bushing Kit (TD4434W). These bushings cushion the front stabilizer bar where it mounts to the frame (front-to-frame position), locating the bar while damping road noise. This kit is a direct-fit replacement for the 2001-2007 Toyota Sequoia, 2007-2013 Toyota Tacoma, and 2003-2006 Toyota Tundra — see the "Vehicles it fits" section for engine-level applications.
- Built to OE standards: Delphi applies its OE engineering to its aftermarket steering and suspension line, with dimensional and material analysis for close compatibility between the original and the replacement.
- Validated to the extreme: Delphi tests parts below -40°C and above 120°C and through 720 hours of salt-spray exposure.
- Consistent service life: manufactured for consistent life across the bushing's use.
- Noise reduction: designed to reduce noise and help restore the vehicle's smooth ride.
Worn stabilizer bar bushings can show up as clunking or rattling from the front on rough roads, a loose-feeling bar, or cracked, deteriorated bushings. If the original bushings are the cause, this kit replaces them.
Interchange: 101-6462 · 101-6519 · 602.44046 · 48815-AD030 · 48815-AF010 · 48815-AF030 · 48815-AF040
1016462 · 1016519 · 60244046 · 48815AD030 · 48815AF010 · 48815AF030 · 48815AF040 · BSK74110 · BSK74110PR · K80819 · GK80819 · MK80819 · JBU1328
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
101-6462, 101-6519, 602.44046, BSK74110, BSK74110PR, K80819, GK80819, MK80819, JBU1328, 48815-AD030, 48815-AF010, 48815-AF030, 48815-AF040
Frequently Asked Questions
What does this Delphi kit do?
It replaces the bushings that cushion and locate the front stabilizer (sway) bar where it mounts to the frame, helping control bar movement and reduce noise.
Which vehicles does TD4434W fit?
It's a direct-fit replacement for the 2001-2007 Toyota Sequoia, 2007-2013 Toyota Tacoma, and 2003-2006 Toyota Tundra. Check the "Vehicles it fits" section for engine-level fitment.
Where do these stabilizer bar bushing kit parts install?
They install at the front-to-frame position, cushioning the stabilizer bar where it is clamped to the frame.
What are signs the sway bar bushings need replacing?
Clunking or rattling from the front over bumps, a loose-feeling stabilizer bar, or cracked and deteriorated bushings. Diagnose the cause before replacing.
Are these bushings built to a quality standard?
Yes. Delphi designs them to OE standards and validates parts below -40°C, above 120°C, and through 720 hours of salt-spray exposure.
