Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4473W
$16.99
(You save)
Quiet the clunks and keep the front stabilizer bar located with the Delphi Sway Bar Bushing Kit TD4473W, a direct-fit replacement for the 2000-2007 Ford Focus. These bushings cushion the front stabilizer (sway) bar where it mounts to the chassis, letting the bar resist body roll while damping the metal-on-metal contact that produces noise. When the original rubber hardens, cracks, or wears, you may hear clunking or rattling from the front when cornering or driving over bumps — if worn stabilizer bar bushings are the cause, this kit replaces them.
Built to OE standards: Delphi applies its OE engineering to the aftermarket steering and suspension portfolio, with extensive dimensional and material analysis for compatibility between the OE and aftermarket part.
Validated to the extreme: tested to withstand temperatures below -40°C and over 120°C, and exposed to 720 hours of salt spray.
Manufactured for consistent life and to reduce noise.
Helps restore the vehicle's smooth ride.
This kit covers the front stabilizer bar bushings for the listed application.
This part cross-references / interchanges with the following part numbers:
YS4Z5484-EA, K80151, GK80151, MK80151, JBU1048
Frequently Asked Questions
What vehicle does the Delphi TD4473W bushing kit fit?
It is a direct-fit replacement for the 2000-2007 Ford Focus. See the Buyer's Guide tab to confirm the exact fit for your vehicle.
Is this a front or rear stabilizer bar bushing kit?
This kit fits the FRONT stabilizer (sway) bar bushings on the listed application.
What does a stabilizer bar bushing kit do?
The bushings cushion the stabilizer bar where it mounts to the chassis, letting the bar resist body roll while damping the contact that causes noise.
What are signs my sway bar bushings may need replacing?
Worn or cracked bushings can cause clunking or rattling from the front when cornering or crossing bumps. Diagnose the source before replacing, as other parts can make similar noises.
What interchange numbers does the TD4473W replace?
It cross-references YS4Z5484-EA, K80151, GK80151, MK80151, and JBU1048.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4473W
Quiet a clunking rear sway bar and keep it located under hard cornering with the Delphi Suspension Stabilizer Bar Bushing Kit (P/N: TD4177W). This kit cushions the rear stabilizer bar where it mounts...
Keep the rear stabilizer bar located and quiet with the Delphi Suspension Stabilizer Bar Bushing Kit (TD5070W). These bushings secure the rear stabilizer bar to the frame, cushioning it against the...
Quiet a clunking, rattling front sway bar and help keep your Mercedes-Benz cornering flat with the Delphi Suspension Stabilizer Bar Bushing Kit TD5885W. This front-to-frame stabilizer bar bushing kit...
Quiet a clunking front sway bar and keep the stabilizer bar located where it belongs with the Delphi Suspension Stabilizer Bar Bushing Kit TD671W. These front stabilizer bar bushings cushion the bar...
Quiet a clunking front sway bar and keep the stabilizer bar properly located with the Delphi Suspension Stabilizer Bar Bushing Kit (TD994W). It drops in as a direct-fit replacement for the front...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
