Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4707W
$14.99
(You save)
Keep the front stabilizer bar located and quiet with the Delphi Suspension Stabilizer Bar Bushing Kit TD4707W. This front stabilizer (sway) bar bushing kit drops in as a direct-fit replacement for the 2002-2003 Suzuki Aerio and the 1998-2002 Suzuki Esteem, cushioning the front sway bar where it mounts to the chassis so it can control body roll without transmitting noise. See the Buyer's Guide tab for engine-level fitment.
Designed to OE standards: Delphi applies its OE steering and suspension expertise to the aftermarket, with dimensional and material analysis for close compatibility between the OE and aftermarket part.
Built for consistent life: manufactured for consistent service life so the front sway bar stays properly located.
Quieter operation: manufactured to reduce noise and help restore the vehicle's smooth ride.
Validated to the extreme: tested below -40°C and above 120°C and exposed to 720 hours of salt spray for OE-level performance.
Worn stabilizer bar bushings can allow clunks or rattles from the front when the bar shifts in dry, cracked bushings, and can dull steering response over bumps. If failed front sway bar bushings are the cause, this kit replaces them.
What vehicles does the Delphi TD4707W bushing kit fit?
It is a direct-fit replacement for the 2002-2003 Suzuki Aerio and the 1998-2002 Suzuki Esteem. Check the Buyer's Guide tab to confirm the fit for your vehicle.
What does a stabilizer bar bushing kit do?
It cushions and locates the front stabilizer (sway) bar where it mounts to the chassis, letting the bar control body roll while limiting noise and metal-to-metal contact.
Is this a front or rear part?
This kit is for the front stabilizer bar position.
What are signs my sway bar bushings need replacing?
Clunks or rattles from the front over bumps and dry, cracked, or worn bushings are common signs. Diagnose the cause first, since other suspension parts can make similar noises.
Are these bushings built to OE standards?
Yes. Delphi designs them to OE standards with dimensional and material analysis, and validates them below -40°C, above 120°C, and through 720 hours of salt spray.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4707W
Suspension Stabilizer Bar Bushing KitDelphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests...
Suspension Stabilizer Bar Bushing KitDelphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests...
Quiet a clunking rear sway bar and keep it located under hard cornering with the Delphi Suspension Stabilizer Bar Bushing Kit (P/N: TD4177W). This kit cushions the rear stabilizer bar where it mounts...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
