Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4708W
$16.99
(You save)
Quiet front-end rattle and keep the front stabilizer bar firmly located with the Delphi Suspension Stabilizer Bar Bushing Kit TD4708W. It installs as a direct-fit replacement for the front sway bar on the 2004-2006 Suzuki Verona — see the Buyer's Guide tab for full engine details.
The bushings cushion the front stabilizer bar where it mounts to the chassis, letting the bar twist to control body roll while limiting metal-to-metal contact. When the original bushings harden, crack, or wear, you may notice clunking or rattling over bumps and vaguer handling — signs these bushings may need replacing.
Built to OE standards: designed using Delphi's OE engineering and dimensional and material analysis for compatibility with the original part.
Consistent life: manufactured for consistent life to help restore the vehicle's smooth ride.
Quieter operation: manufactured to reduce noise from the stabilizer bar mounts.
Tested to the extreme: validated below -40°C and over 120°C, plus 720 hours of salt spray.
This stabilizer bar bushing kit is a straightforward way to renew worn front sway bar mounts.
What vehicle does the Delphi TD4708W bushing kit fit?
It's a direct-fit replacement for the front stabilizer bar bushings on the 2004-2006 Suzuki Verona. Check the Buyer's Guide tab to confirm fitment for your vehicle.
What does a sway bar bushing kit do?
The bushings cushion and locate the front stabilizer bar where it mounts to the chassis, letting the bar twist to control body roll while limiting metal-to-metal contact and noise.
What are signs these bushings may need replacing?
Clunking or rattling over bumps, squeaks from the stabilizer bar mounts, and vaguer handling can indicate worn, cracked, or hardened bushings. Diagnose the cause before replacing.
Are these bushings built to OE standards?
Yes. Delphi designs them to OE standards using its dimensional and material analysis for compatibility with the original part, and validates them below -40°C, over 120°C, and through 720 hours of salt spray.
Is this a front or rear stabilizer bar kit?
This kit is for the front stabilizer bar on the listed application.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4708W
Quiet a clunking rear sway bar and keep your suspension moving in sync with the Delphi Suspension Stabilizer Bar Bushing Kit (TD918W). This rear stabilizer bar bushing kit drops in as a direct-fit...
Quiet the clunks and rattles from your front stabilizer bar and keep it located precisely with the Delphi Suspension Stabilizer Bar Bushing Kit TD956W. It installs as a direct-fit replacement for the...
Quiet a rattling rear sway bar and keep body roll in check with the Delphi Suspension Stabilizer Bar Bushing Kit (TD4786W), a REAR sway bar bushing kit built to Delphi's OE standards. It drops in as...
Cut down clunks and rattles from a worn stabilizer bar mount with the Delphi Suspension Stabilizer Bar Bushing Kit TD4628W. These bushings cushion the front sway bar where it clamps to the chassis,...
Quiet the rattle and clunk from a worn front sway bar mount with the Delphi Suspension Stabilizer Bar Bushing Kit TD4253W. These front stabilizer bar bushings cushion the bar where it clamps to the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
