Quiet a clunking, rattling front stabilizer bar and keep it working with the Delphi Suspension Stabilizer Bar Bushing Kit TD5099W, a direct-fit replacement that installs on the front sway bar of the 1965-1973 Ford Mustang. These bushings cushion and locate the front stabilizer bar against the chassis, letting the bar limit body roll through corners while isolating the metal-to-metal contact that causes creaks and knocks.
Delphi OE expertise: Delphi's OE safety technology is fitted to millions of vehicles worldwide, and that same knowledge is applied to its aftermarket steering and suspension range.
- Tested to the extreme: parts withstand temperatures below -40°C and above 120°C and endure 720 hours of salt spray, with extensive dimensional and material analysis for close OE-to-aftermarket compatibility.
- Designed to OE standards: Delphi bushings are engineered to OE standards and manufactured for consistent life.
- Noise reduction: manufactured to reduce noise and help restore the vehicle's smooth ride.
Worn or cracked stabilizer bar bushings are a common source of front-end clunk over bumps, extra body roll, and vibration — signs this kit may need replacing. Inspect both sides and replace together for balanced handling.
Interchange: DM35.490397
DM35490397 · BSK85210PR · K7096 · K90393 · MK90297 · JBU1351
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
DM35.490397, BSK85210PR, K7096, K90393, MK90297, JBU1351
Frequently Asked Questions
What vehicle does this stabilizer bar bushing kit fit?
It is a direct-fit replacement for the front stabilizer bar on the 1965-1973 Ford Mustang. Check the "Vehicles it fits" section to confirm the correct application for your vehicle.
Is this bushing kit for the front or rear stabilizer bar?
The catalog lists it for the FRONT stabilizer bar. It cushions and locates the front sway bar against the chassis.
What does a sway bar bushing do?
It cushions and locates the stabilizer bar to the chassis, allowing the bar to limit body roll while isolating metal-to-metal contact that causes noise.
What are the signs my stabilizer bar bushings need replacing?
Common signs include a clunk or knock from the front over bumps, increased body roll, and vibration. Worn or cracked bushings may need replacing.
Has this Delphi kit been durability tested?
Yes. Delphi tests parts below -40°C and above 120°C and through 720 hours of salt spray, with dimensional and material analysis for close OE compatibility.
