Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD5625W
$13.99
(You save)
Quiet the clunks and rattles from your front sway bar with the Delphi Suspension Stabilizer Bar Bushing Kit (P/N: TD5625W), a direct-fit replacement for the 2009-2011 Honda Fit (see the Buyer's Guide tab for engine details). These front stabilizer bar bushings cushion the bar where it clamps to the chassis, helping keep the sway bar located so it can control body roll while damping road noise. If worn, cracked, or noisy front bushings are the cause of clunking or excess movement, this kit replaces them.
Built to OE standards: Delphi bushings are designed to OE standards, drawing on the OE safety technology fitted to millions of vehicles worldwide.
Tested to the extreme: validated for performance from below -40°C to over 120°C and through 720 hours of salt spray, with extensive dimensional and material analysis for OE-to-aftermarket compatibility.
Consistent, quieter service: manufactured for consistent life and to reduce noise.
Smoother ride: designed to assist in restoring the vehicle's smooth ride.
Front bushings wear as a pair, so inspect and replace both sides together for balanced handling.
This part cross-references / interchanges with the following part numbers:
51306-TK6-A01, K201445, JBU2199
Frequently Asked Questions
What vehicle does this Delphi TD5625W bushing kit fit?
It's a direct-fit replacement for the 2009-2011 Honda Fit. Check the Buyer's Guide tab to confirm the fit for your exact vehicle.
Is this a front or rear stabilizer bar bushing kit?
This is a front sway bar bushing kit, cushioning the front stabilizer bar where it mounts to the chassis.
What is a stabilizer bar bushing kit?
It's a set of bushings that cushion and locate the sway bar at its chassis mounts, helping control body roll while reducing noise and vibration.
What are signs these bushings may need replacing?
Clunking or rattling from the front over bumps and increased body roll can be signs. Diagnose the cause first, as other worn parts can produce similar symptoms.
Should I replace both bushings at once?
Yes, it's best to replace the left and right front bushings together as a matched pair for even, balanced handling.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD5625W
Quiet a clunking, rattling front sway bar and help keep your Mercedes-Benz cornering flat with the Delphi Suspension Stabilizer Bar Bushing Kit TD5885W. This front-to-frame stabilizer bar bushing kit...
Quiet a clunking front sway bar and keep the stabilizer bar located where it belongs with the Delphi Suspension Stabilizer Bar Bushing Kit TD671W. These front stabilizer bar bushings cushion the bar...
Quiet a clunking front sway bar and keep the stabilizer bar properly located with the Delphi Suspension Stabilizer Bar Bushing Kit (TD994W). It drops in as a direct-fit replacement for the front...
Quiet a clunking rear sway bar and keep it precisely located with the Delphi Suspension Stabilizer Bar Bushing Kit (TD935W). This rear kit drops in for a wide range of BMW models, including the...
Quiet a clunking, knocking rear sway bar and keep the stabilizer bar located properly with the Delphi Suspension Stabilizer Bar Bushing Kit (TD996W). This rear sway bar bushing kit cushions the bar...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
