Delphi Suspension Stabilizer Bar Link Kit P/N:TC2367
$33.99
(You save)
Keep body roll in check and quiet suspension clunk with the Delphi Suspension Stabilizer Bar Link Kit TC2367, a rear sway bar link kit that connects the rear stabilizer bar to the suspension so cornering forces are shared side to side. It's a direct-fit replacement for the 2006-2011 Hyundai Azera, 2006-2010 Hyundai Sonata, and 2007-2009 Kia Amanti — see the Buyer's Guide tab for engine-level fitment. If worn links are the cause of your clunk or rattle over bumps and through turns, this kit replaces them.
OE-engineered durability: Delphi carries its OE steering and suspension expertise into the aftermarket, running parts below -40°C and above 120°C plus 720 hours of salt spray, with dimensional and material analysis for close OE-to-aftermarket compatibility.
Fatigue tested: each link is fatigue tested to guard against failure.
Ultrasonic molding: built with ultrasonic molding to help prevent future weld breakage.
Micron tolerances: machined to micron tolerances for durability and smooth joint operation.
Anti-corrosion protection: applied to each part for corrosion prevention and enhanced appearance.
It's a stabilizer bar link kit that connects the rear stabilizer bar to the suspension, transferring forces side to side to help control body roll during cornering.
Is this a front or rear link kit?
It's a rear sway bar link kit. It connects the rear stabilizer bar to the suspension on the listed applications.
Which vehicles does the TC2367 fit?
It's a direct-fit replacement for the 2006-2011 Hyundai Azera, 2006-2010 Hyundai Sonata, and 2007-2009 Kia Amanti. Check the Buyer's Guide tab for engine-level fitment.
What are signs my sway bar links may need replacing?
Clunking, rattling, or knocking from the rear suspension over bumps and through turns, along with looser handling, are signs the links may be worn. Diagnose the cause before replacing.
How is this Delphi link kit built to last?
Each link is fatigue tested, ultrasonically molded to help prevent weld breakage, machined to micron tolerances for smooth joint operation, and treated with anti-corrosion protection.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Link Kit P/N:TC2367
Keep body lean in check and quiet the clunks with the Delphi Rear Suspension Stabilizer Bar Link Kit (TC2616) — a direct-fit replacement for the 2002-2007 Mitsubishi Lancer (see the Buyer's Guide tab...
Tighten up front-end response and quiet the clunks with the Delphi Suspension Stabilizer Bar Link Kit TC6165. These front sway bar links connect the stabilizer bar to the suspension, transferring...
Quiet the clunks and keep the rear stabilizer bar tied to the suspension with the Delphi Suspension Stabilizer Bar Link Kit TC6526. This rear-position stabilizer bar link kit drops in as a direct-fit...
Keep body roll in check and quiet the rattles with the Delphi Front Suspension Stabilizer Bar Link Kit TC6540. This front sway bar link connects the stabilizer bar to the suspension so the bar can...
Keep body roll in check and restore a tight, controlled feel over uneven pavement with the Delphi Suspension Stabilizer Bar Link Kit TC2409. This kit connects the rear stabilizer bar to the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
