Delphi Suspension Stabilizer Bar Link Kit P/N:TD4388W
$10.99
(You save)
Tie your front stabilizer bar to the suspension and quiet the sway-bar rattle and body roll with the Delphi Suspension Stabilizer Bar Link Kit (TD4388W). This front sway bar link kit connects the front stabilizer bar to the control arm or strut, and it installs as a direct-fit replacement for a long list of applications including the 1991-1996 Dodge Dakota, 1999-2003 Dodge Ram 1500 Van, 1968-1973 Ford Mustang, 1962-1971 Ford Ranchero, 1968-1969 American Motors AMX and Javelin, and 1974-1978 Toyota Corona. See the Buyer's Guide tab for the full list of 26 applications.
Fatigue tested: Delphi sway bar links are fatigue tested to help avoid failure in service.
Ultrasonic molding: built with ultrasonic molding to help prevent future weld breakage.
Micron tolerances: machined to micron tolerances for durable, smooth joint operation.
Corrosion protection: anti-corrosion protection applied to each part for corrosion prevention and improved appearance.
Delphi validates to OE performance targets, with parts withstanding temperatures below -40°C and over 120°C and enduring 720 hours of salt spray, plus dimensional and material analysis for OE-to-aftermarket compatibility. Worn links can cause clunking over the stabilizer bar and reduced body-roll control.
It links the front stabilizer (sway) bar to the suspension, allowing the bar to resist body roll during cornering while accommodating suspension movement.
Is this a front or rear sway bar link?
This kit is cataloged for the FRONT position, connecting the front stabilizer bar to the suspension on the listed applications.
What are signs my sway bar links may need replacing?
Clunking or rattling from the stabilizer bar over bumps, looseness at the link joints, and reduced body-roll control during cornering can indicate worn links.
How was this Delphi link kit tested?
Delphi fatigue tests the links to help avoid failure and validates parts through 720 hours of salt spray and temperatures below -40°C to over 120°C for OE performance.
Which vehicles does TD4388W fit?
It fits 26 applications, including the 1991-1996 Dodge Dakota, 1968-1973 Ford Mustang, 1962-1971 Ford Ranchero, and 1974-1978 Toyota Corona. See the Buyer's Guide tab for the full list.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Link Kit P/N:TD4388W
Quiet a clunking front end and help keep body lean in check with the Delphi Suspension Stabilizer Bar Link Kit TC8477. This front sway bar link connects the stabilizer bar to the suspension on the...
Tie the front stabilizer bar to the suspension and help control body roll through every corner with the Delphi Suspension Stabilizer Bar Link Kit (TC2265). This front sway bar link kit is a...
Keep body lean in check and quiet the clunks with the Delphi Rear Suspension Stabilizer Bar Link Kit (TC2616) — a direct-fit replacement for the 2002-2007 Mitsubishi Lancer (see the Buyer's Guide tab...
Keep the front sway bar working with the driver — and quiet the clunks and rattles that a worn link lets through — with the Delphi Suspension Stabilizer Bar Link Kit TC2912. This front sway bar link...
Keep your rear stabilizer bar tied firmly to the suspension with the Delphi Suspension Stabilizer Bar Link Kit TC2919. This rear-position sway bar link kit drops in as a direct-fit replacement for...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
