Raybestos Brakes Disc Brake Caliper P/N:FRC11396
Clamp the brake pads firmly against the front-left rotor with the Raybestos R-Line Remanufactured Semi-Loaded Caliper and Bracket Assembly, part number FRC11889. It fits many vehicles, among them the 2006-2009 Chevrolet Trailblazer, the 2006-2009 GMC Envoy and the 2006 Chevrolet SSR. It is listed for all engines, and the Trailblazer and Envoy listings also call out the L6-4.2L. See the Buyer's Guide tab for the full list.
This Raybestos R-Line disc brake caliper is a remanufactured OE unit with a non-plated finish, supplied with its bracket. Every unit gets all-new rubber and sealing components. The castings, guide pins and brackets are carefully inspected before they are reused, and each assembly is rigorously tested.
Specifications: cast iron caliper casting, 2 in (50.8 mm) piston diameter and M10x1 bleeder screw thread. Position: front left. Quantity per application: 1. Country of origin: Mexico.
A caliper that leaks fluid, sticks, drags, causes a pull when braking or leaves uneven pad wear may need replacing. Diagnose the cause before you replace any parts. This listing is for one front-left unit. Replacing both front calipers together is commonly recommended for balanced braking. Bleed the brake system after installation according to the vehicle service procedure.
Interchange: 15-14310 · 99-17388A · 18-B5004A · 18-P5004A · 141.66046 · SC1037-1
1514310 · 9917388A · 18B5004A · 18P5004A · 14166046 · SC10371
This part cross-references / interchanges with the following part numbers:
Will this Trailblazer caliper fit my Chevrolet Trailblazer?
It is listed as the front-left caliper for the 2006-2009 Chevrolet Trailblazer, for all engines including the L6-4.2L. Check the Buyer's Guide tab to confirm your exact vehicle.
What parts are replaced with new on this remanufactured caliper?
Seals, boots, bleeder screws, abutment hardware, banjo bolts and O-rings are replaced with new materials. Castings, guide pins and brackets are inspected before they are reused.
What are the piston size and bleeder thread?
The caliper piston diameter is 2 in (50.8 mm) and the bleeder screw thread is M10x1. The caliper casting is cast iron.
What are signs that a brake caliper may need replacing?
Common signs include fluid leaking at the caliper, a pull to one side when braking, a dragging or sticking brake, and uneven pad wear. Diagnose the cause before you replace parts.
Which position does it install in, and how many are included?
This listing is one caliper and bracket assembly for the front-left position. Replacing both front calipers together is commonly recommended, and the brakes must be bled after installation.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.