Dorman - First Stop Brake Hydraulic Hose P/N:H622780
$38.99
(You save)
Keep hydraulic pressure moving to the front-right brake caliper with the Dorman - First Stop Brake Hydraulic Hose (H622780). This flexible hose carries pressurized brake fluid from the vehicle's hard line to the caliper while flexing with suspension and steering movement, and it installs as a direct-fit replacement for the front-right position on the 2017-2020 Chrysler Pacifica [All].
Dorman precision-engineers this hose to the correct measurements for the listed vehicle and position, so it fits the factory routing for a straightforward installation.
Position-specific fit: manufactured to precise measurements for an exact fit and easy installation on the front-right corner.
Durable design: built with EPDM rubber and specially coated, corrosion-resistant fittings.
Quality assured: DOT approved, with materials tested to government-regulated safety and durability standards.
Fittings & size: banjo fitting at End 1 and an inverted-flare junction fitting at End 2 (M10 x 1.0 thread); both fittings are treated steel, with an overall length of 25 in.
Includes a gasket or seal. No mounting hardware, bracket, or jacket is included; consult the vehicle service information for the correct fasteners and whether they may be reused. Country of origin: China.
Interchange: 150.63103 · 68223522AA · 68223522AB · 2207654. Manufacturer part number H622780.
This part cross-references / interchanges with the following part numbers:
150.63103, 68223522AA, 68223522AB, 2207654
Frequently Asked Questions
What vehicle does this brake hydraulic hose fit?
It's a direct-fit replacement for the front-right position on the 2017-2020 Chrysler Pacifica [All] (quantity 1). See the Buyer's Guide tab to confirm fitment for your vehicle.
What does a brake hydraulic hose do?
It carries pressurized brake fluid from the vehicle's steel hard line to the caliper while flexing with suspension and steering movement to keep the hydraulic circuit sealed.
What fittings and size does it have?
It has a banjo fitting at End 1 and an inverted-flare junction fitting at End 2 with an M10 x 1.0 thread. Both fittings are treated steel, and the overall length is 25 in.
Is any mounting hardware or bracket included?
No. Mounting hardware, a bracket, and a jacket are not included; a gasket or seal is included. Consult the service information for the correct fasteners and whether they may be reused.
Is this hose DOT approved?
Yes, it is DOT approved and made with EPDM rubber and specially coated, corrosion-resistant fittings, with materials tested to government-regulated safety and durability standards.
Write a Review
Dorman
Dorman - First Stop Brake Hydraulic Hose P/N:H622780
Keep brake fluid moving safely between the rigid brake line and the front caliper with the Dorman First Stop Brake Hydraulic Hose H620298. It installs as a direct-fit replacement for the front left...
Keep pressurized brake fluid flowing to the wheel with the Dorman - First Stop Brake Hydraulic Hose H620893. This flexible hydraulic line carries fluid from the rigid brake line to the wheel, flexing...
Keep hydraulic pressure moving to the rear brakes with the Dorman - First Stop Brake Hydraulic Hose H38406, a flexible replacement line built for the rear left or rear right position on the 1985-1989...
Move pressurized brake fluid from the hard line to the caliper without kinking as the suspension and steering move, with the Dorman - First Stop Brake Hydraulic Hose H380583. This front-left flexible...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
