Dorman 686-412 front right steering knuckle for the 2016-2022 Honda HR-V connects the front right wheel to the suspension. This Dorman steering knuckle replaces a damaged or worn original knuckle.
- Cast steel knuckle made to resist cracks
- Knuckle body resists rust and corrosion
- Replacement for a knuckle damaged by curb strikes, potholes or collisions
Quick facts
- Part: Dorman 686-412 steering knuckle
- Fits: 2016-2022 Honda HR-V
- Position: Front right
- Material: Steel
- Condition: New
Knocking, uneven tire wear or steering and alignment trouble can come from several parts, including worn bushings. Before replacing the knuckle, look it over with the engine off for cracks, bends or curb-strike damage. Each side of the front axle takes one knuckle. This listing is the front right only; the front left is a separate part, and the two sides are normally replaced together.
Fits
This Dorman OE Solutions steering knuckle is a direct-fit replacement for the 2016-2022 Honda HR-V.
Specifications
Fit and size
- Position: Front right
- Quantity per vehicle: 1
- Caliper mounting holes: 2
- Caliper mounting hole diameter: 11.7 mm
- Sensor hole diameter: 9.8 mm
Build and materials
- Material: Steel
- Construction: Cast
- Condition: New
- Country of origin: China
In the box
One bare steering knuckle. The hub, axle, mounting hardware and instruction manual are not included, and the old fasteners may not be reusable, so plan on new hardware.
Installation notes
- No special tools are needed for installation.
Interchange: 51211T7W000
Frequently Asked Questions
Is the Dorman 686-412 steering knuckle the right one for a 2016-2022 Honda HR-V?
Yes. Dorman 686-412 is the front right steering knuckle for the 2016-2022 Honda HR-V; the front left side is a separate part.
Does the Dorman 686-412 knuckle come with the hub or axle?
No. Dorman 686-412 is one bare cast steel knuckle. The hub, axle, mounting hardware and instruction manual are not included.
What size are the caliper and sensor holes on this front right knuckle?
The two caliper mounting holes are 11.7 mm in diameter, and the sensor hole is 9.8 mm.
Can uneven tire wear mean a steering knuckle is bad?
It can, though worn bushings, steering parts or alignment can cause the same wear. A shop can test the steering and suspension to find the cause.
Does this knuckle cross-reference to 51211T7W000?
Yes. 51211T7W000 is listed as an interchange number for this front right steering knuckle.
