Keep your Subaru's front suspension tight and predictable with the Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly 520-020. This front right lower assembly is a direct replacement for the original equipment on the specific listed applications, dropping in for the 2019-2025 Subaru Ascent — see the Buyer's Guide tab for engine-level details.
A worn control arm or ball joint can show up as clunking over the front suspension during acceleration or turns, uneven tire wear, or loose, wandering steering. If a failed front right lower control arm or its ball joint is the cause, this assembly replaces it as a single unit.
Interchange: CA16533 · 11CB80370 · GS801237 · CMS801237 · 2609641 · 20202XC00A
This part cross-references / interchanges with the following part numbers:
What vehicle does the 520-020 assembly fit?
It is a direct-fit replacement for the 2019-2025 Subaru Ascent. Check the Buyer's Guide tab to confirm the exact application for your vehicle.
Which position is this control arm?
This is the front right (passenger side) lower control arm and ball joint assembly for the listed Subaru Ascent applications.
Does it include the ball joint and bushings?
Yes. Each assembly comes with a pre-installed ball joint and bushings, so you replace the worn parts as one complete unit and save install time.
What are signs this control arm may need replacing?
Common signs include clunking from the front suspension during acceleration or turns, uneven tire wear, and loose or wandering steering. Diagnose the cause before replacing.
Should I replace both sides at once?
This listing covers the front right lower assembly only. Replacing worn suspension parts on both sides together can help keep handling balanced, but follow the vehicle service procedure.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
