Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:520-520
Dorman 520-458 front right upper control arm with ball joint for the 2002-2010 Lexus SC430 and other vehicles links the wheel assembly to the vehicle and pivots as the suspension moves. It is also called a control arm and ball joint assembly.
A clunk over bumps, loose or wandering steering or uneven front tire wear can mean the ball joint or bushings are worn, though a worn tie rod end or wheel bearing can produce similar signs, so find the cause before you replace the arm.
This Dorman control arm is a direct-fit replacement for the 1998-2005 Lexus GS300, the 2001-2004 Lexus GS430 and the 2002-2010 Lexus SC430. Each side of the front axle takes one upper arm; this listing is the front right, the front left upper is a separate part ordered separately, and both are normally replaced together. Don't see your Lexus here? Look up your year and model in the "Vehicles it fits" section.
Fit and size
Build and materials
One control arm with ball joint, with mounting hardware. A grease fitting is not included.
Interchange: 102-5781 · 622.44048 · 623.44048
TC2933 · CA8337 · 3CB86046 · RK620335 · FA4922 · GS86104 · CMS86104 · 2605812 · SK520458 · JTC7596 · 4861039085
This part cross-references / interchanges with the following part numbers:
Will this Lexus SC430 control arm fit a 2002-2010 model?
Yes. Dorman 520-458 is the front right upper control arm for the 2002-2010 Lexus SC430. It also fits other Lexus models; the "Vehicles it fits" section shows whether yours is one.
Are the Dorman control arm bushings already installed on this arm?
Yes. The rubber bushings and the ball joint come pre-installed on Dorman 520-458, and the ball joint is pre-greased.
Does the Dorman 520-458 include mounting hardware and a grease fitting?
Yes, mounting hardware is included with Dorman 520-458; a grease fitting is not. The package holds one control arm with ball joint.
Is this Dorman upper control arm made of iron?
Yes. The arm is iron, casting/forged type, with rubber bushings, and additional coatings resist rust and corrosion.
What thread size does the ball joint stud on this front right upper arm have?
The ball joint stud is threaded, with a 14 mm thread diameter. The arm's mounting hole is 12.3 mm in diameter.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.