Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:520-520
Replace the front left lower control arm on your 1999-2003 Nissan Maxima, 2000-2001 Infiniti I30 or 2002-2004 Infiniti I35 with this Dorman control arm, part number 520-517, which arrives with its ball joint and bushings already installed. As a Dorman lower control arm for the front left position, it directly replaces the original assembly on the listed applications.
The control arm links the wheel's steering knuckle to the vehicle's chassis. Its ball joint acts as a pivot, letting the wheel move with the suspension and turn with the steering.
Signs this part may need replacing include clunking or knocking over bumps, loose or wandering steering, uneven tire wear, and visibly worn bushings. If a worn arm, bushing or ball joint is the cause, this Dorman suspension control arm and ball joint assembly replaces them as a single unit. A wheel alignment is recommended after installation.
Interchange: 102-4931 · 820-65943B · 623.42057
1024931 · 82065943B · 62342057 · TC5725 · CA14322 · 5CB30029 · CK620355 · RK620355 · FA4285 · GS20458 · CMS20458 · 2605412 · 545012Y411 · 545012Y412 · 545012Y421 · 545012Y470 · 545015Y720 · 545016Y301 · SRK620355 · 1516001 · JTC2474
This part cross-references / interchanges with the following part numbers:
Is this the right 1999-2003 Nissan Maxima control arm for the front left lower position?
Yes. Dorman 520-517 is listed for the front left lower position on the 1999-2003 Nissan Maxima. Check the Buyer's Guide tab to confirm your exact vehicle.
What comes with Dorman 520-517?
The control arm comes with the ball joint and bushings pre-installed, so the arm and joint are replaced together in one step.
What does a lower control arm do?
It connects the wheel's steering knuckle to the chassis. Its ball joint pivots so the wheel can move with the suspension and turn with the steering.
What are signs the control arm may need replacing?
Common signs include clunking over bumps, loose or wandering steering, uneven tire wear, and worn bushings. Diagnose the cause before replacing parts.
Do I need a wheel alignment after installing it?
Yes. Replacing a control arm can change the suspension geometry, so a wheel alignment is recommended after installation.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.