Tackle a worn front suspension link without pressing in a single joint: the Dorman control arm 520-647 from Dorman - OE Solutions arrives with its ball joint and bushings already installed. This front left upper arm is a direct-fit replacement for the 1997-2001 Honda CR-V, and Dorman designs it to directly replace the original assembly on that application.
The upper control arm connects the steering knuckle to the vehicle's frame. It lets the wheel travel up and down while holding it in position. The ball joint acts as the pivot, and the bushings help isolate the mounting points.
- Direct replacement: built to take the place of the original assembly on the specified vehicle applications.
- Pre-installed components: the ball joint and bushings come already installed, which saves time and labor.
- Tested for ride quality: put through Dorman's industry-leading evaluation process, which aims for a smooth ride, directional stability and predictable dynamics.
- Added corrosion protection: additional coatings help resist rust and corrosion.
Clunking over bumps, wandering steering or uneven tire wear can come from a worn ball joint or worn bushings. If either one is the cause, this Dorman suspension control arm and ball joint assembly replaces the whole unit in one step. It is sold individually for the left side, and replacing both upper arms together is recommended. Follow the vehicle service information for the correct fasteners and torque, and have the alignment checked after installation.
Interchange: 102-4801 · 810-70212B · 623.40036
1024801 · 81070212B · 62340036 · TC2920 · CA8420 · 51460S10020 · 3CB60058 · CK80884 · K80884 · RK80884 · FA4655 · GS20114 · CMS20114 · 2605760 · SRK80884 · JTC626
This part cross-references / interchanges with the following part numbers:
102-4801, 810-70212B, 623.40036, TC2920, CA8420, 51460S10020, 3CB60058, CK80884, K80884, RK80884, FA4655, GS20114, CMS20114, 2605760, SRK80884, JTC626
Frequently Asked Questions
Will this 1997-2001 Honda CR-V control arm fit my vehicle?
It is a direct-fit replacement for the front left upper position on the 1997-2001 Honda CR-V. Check the "Vehicles it fits" section to confirm your exact vehicle.
What comes pre-installed on this arm?
The ball joint and bushings come already installed in the arm, so you don't have to press them in separately. This saves time and labor.
What are signs the upper control arm may need replacing?
Clunking over bumps, loose or wandering steering, uneven tire wear, or visible play at the ball joint can be signs. Have the suspension inspected to confirm the cause before replacing parts.
Should I replace both sides at the same time?
This listing is for one front left upper arm, sold individually. Replacing the left and right upper arms together is recommended.
Do I need an alignment after installing it?
Yes, a wheel alignment is recommended after replacing a control arm. Follow the vehicle service information for torque specs and for whether the original fasteners may be reused.
