Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:521-368
Help keep your front suspension steady with this Dorman control arm, part number 521-061. It is a front left upper unit designed to directly replace the original assembly on the 2007-2010 Hyundai Sonata, 2007-2011 Hyundai Azera and 2007-2009 Kia Amanti. With the ball joint and bushings already installed, it lets you replace the arm, joint and bushings in a single job.
As a Dorman suspension control arm and ball joint assembly, this part connects the wheel assembly to the vehicle's structure. It lets the wheel travel up and down while holding it in position, and the ball joint provides the pivot the steering knuckle turns on. Clunking over bumps, loose or wandering steering, or uneven tire wear may mean the arm, its bushings or its ball joint need replacing. These signs can also have other causes, so inspect the suspension before you order.
This listing is for one front left upper assembly. Replacing the left and right sides together is recommended. Follow the vehicle service information for the correct fasteners and torque values, and have the wheel alignment checked after installation. See the Buyer's Guide tab for engine details and the full fitment chart.
Interchange: 102-5356 · 810-234726B · 623.51016
1025356 · 810234726B · 62351016 · TC3486 · CA4564 · 544103F600 · 544103f601 · 3CB90074 · RK621230 · GS90158 · CMS90158 · 2606153 · 2607988 · SRK621230 · X18CJ1844 · JTC7769
This part cross-references / interchanges with the following part numbers:
What does a front left upper control arm with ball joint do?
It connects the wheel assembly to the vehicle's structure and lets the wheel move up and down. The ball joint gives the steering knuckle a pivot to turn on.
Is this a direct-fit control arm for the 2007-2010 Hyundai Sonata?
Yes. It is listed as a direct-fit front left upper replacement for the 2007-2010 Hyundai Sonata. The Buyer's Guide tab shows the full fitment chart.
What comes with Dorman part 521-061?
Each assembly includes the control arm with the ball joint and bushings already installed, so those parts do not need to be fitted separately.
What are signs the control arm or ball joint may need replacing?
Common signs include clunking over bumps, loose or wandering steering, and uneven tire wear. These can have other causes, so inspect the suspension before replacing parts.
Should I replace both sides at the same time?
This listing is for one front left upper assembly. Replacing the left and right sides together is recommended, and a wheel alignment check is advised after installation.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.