Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:524-524
Help restore a smooth, steady ride with the Dorman control arm, part number 524-152, built for the front right lower position. It installs as a direct replacement for the original assembly on the 2004-2009 Toyota Prius, so you can repair a worn front corner without sourcing separate components.
This Dorman suspension control arm and ball joint assembly arrives ready to install. It went through Dorman's industry-leading evaluation process, which targets a smooth ride, directional stability and predictable dynamics.
Signs this Dorman lower control arm may need replacing include clunking over bumps, loose or wandering steering, uneven tire wear and visible play at the ball joint. If a worn arm or ball joint is the cause, this assembly replaces both in one piece. Diagnose the suspension first to confirm the source of the symptom. A wheel alignment is generally recommended after installation. Consult the vehicle service information for torque specifications and fasteners.
Interchange: TC4000 · CA14671 · 4CB86188 · RK640959 · GS861129 · CMS861129 · 2607904 · X50CJ0982 · 4333049055 · 4806847030 · 4806847040
This part cross-references / interchanges with the following part numbers:
What does this control arm do?
It connects the wheel's steering knuckle to the vehicle's chassis. This lets the wheel move up and down while holding it in position, and the ball joint provides the pivot point for steering.
Does this Prius control arm fit my car?
It is a direct replacement for the front right lower control arm on the 2004-2009 Toyota Prius. Check the Buyer's Guide tab to confirm it matches your vehicle.
What comes pre-installed on the arm?
The ball joint and bushings come pre-installed, so you don't have to press them in separately. This saves time and labor during the repair.
What are signs the lower control arm may need replacing?
Signs include clunking over bumps, loose or wandering steering, uneven tire wear and play at the ball joint. Inspect the suspension to confirm the cause before replacing parts.
Is an alignment needed after installation?
A wheel alignment is generally recommended after replacing a control arm. Follow the vehicle service information for torque specs and whether the original fasteners can be reused.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.