Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:524-524
Help restore a smooth, stable ride with this Dorman control arm, part number 524-186, a direct replacement for the front right lower control arm on the 2008-2011 Subaru Impreza. See the Buyer's Guide tab for engine and trim details.
This Dorman suspension control arm and ball joint assembly comes with the ball joint and bushings already installed, so the front right lower corner can be serviced as one unit.
This Dorman lower control arm is sold individually for the right side. Replacing both sides together is recommended for balanced handling. Possible signs that the control arm or its ball joint needs replacing include clunking or knocking over bumps, loose or wandering steering, uneven tire wear and cracked or torn bushings. Other suspension parts can cause similar symptoms, so diagnose the cause before replacing. Have a wheel alignment checked after installation.
Interchange: 102-7963
1027963 · TC7624 · CA14592 · 5CB801134 · RK623400 · GS80181 · CMS80181 · 2606948 · 2606948M · 20202AG182 · 20202AG183
This part cross-references / interchanges with the following part numbers:
What does a control arm with ball joint do?
It links the steering knuckle to the vehicle's chassis, so the wheel can move up and down. The ball joint lets the knuckle pivot for steering, and the bushings help isolate road vibration.
Is this the right control arm for a 2008-2011 Subaru Impreza?
It is cataloged as the front right lower control arm for the 2008-2011 Subaru Impreza. The Buyer's Guide tab shows the full application details.
What is included with the Dorman suspension control arm 524-186?
Each assembly comes with the ball joint and bushings pre-installed, so it installs as one unit. Check the vehicle service information for the correct fasteners.
What are signs this part may need replacing?
Possible signs include clunking over bumps, loose or wandering steering, uneven tire wear, and cracked or torn bushings. Have the suspension inspected to confirm the cause before replacing.
Do I need an alignment after installing it?
A wheel alignment is recommended after replacing a control arm. Follow the vehicle service information for torque specifications and for whether the original fasteners may be reused.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.