Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:524-344
$93.99
(You save)
Replace a worn front right lower forward control arm and ball joint on your car with the Dorman - OE Solutions OE FIX Suspension Control Arm and Ball Joint Assembly 524-344. It's engineered as a direct-fit replacement for the 2005-2010 Chrysler 300, 2008-2010 Dodge Challenger, 2006-2010 Dodge Charger and 2005-2008 Dodge Magnum — RWD models with high-performance suspensions. On many of these vehicles the factory bushings are undersized and made from rubber that weakens and breaks down prematurely, and this assembly is built to address that root cause.
Upgraded bushing: features an oversized, heavy-duty two-piece bushing that distributes the suspension load over a greater area and is made from denser, more durable rubber for a more permanent repair.
Position-specific: engineered exclusively to replace a failed front right lower forward arm on the specified RWD Chrysler and Dodge vehicles.
Fleet-friendly: designed to help increase uptime and reduce maintenance costs versus repeatedly installing factory-style arms.
Simple installation: professional technicians and experienced DIYers can install it without special tools and with no shop press needed.
For balanced results, replacing both assemblies is recommended.
It's a direct-fit replacement for the 2005-2010 Chrysler 300, 2008-2010 Dodge Challenger, 2006-2010 Dodge Charger and 2005-2008 Dodge Magnum. See the Buyer's Guide tab to confirm your vehicle.
Which position is this control arm for?
It's engineered specifically to replace the front right lower forward control arm and ball joint on the listed RWD Chrysler and Dodge models with high-performance suspensions.
How is this different from the original arm?
It features an oversized, heavy-duty two-piece bushing made from denser, more durable rubber that spreads the suspension load over a greater area, addressing a common cause of factory arm failure.
Do I need to replace both control arms?
For balanced performance, Dorman recommends replacing both assemblies. This listing is for one control arm and ball joint assembly.
Are special tools required for installation?
No. Dorman states this assembly can be installed by professional technicians and experienced DIYers without any special tools and with no shop press needed.
Write a Review
Dorman
Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:524-344
Suspension Control Arm And Ball Joint AssemblyThis suspension control arm and ball joint assembly is a direct replacement for the original equipment on specific vehicle applications. An...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
