Dorman - OE Solutions Suspension Control Arm P/N:521-834
Dorman 521-256 front right lower lateral arm for the 2009-2012 Audi A4 and other vehicles locates the front right wheel as the suspension moves. The arm is also sold as a suspension control arm.
A worn arm or tired bushings can show up as a clunk over bumps, uneven tire wear or a pull to one side, and other suspension parts can give similar symptoms. With the engine off, look the arm over for a bend or for split or cracked bushing rubber to find the cause before you replace it.
The 2009-2012 Audi A4, 2009-2012 Audi A4 Quattro and 2008-2012 Audi A5 each take one on the front right, and many other vehicles fit as well. It is a direct replacement, precision-engineered to match the design and dimensions of original components. This listing is one arm for the front right; the front left is a separate part, and the other side of that axle is normally done at the same time. Not seeing your car here? Put its year and model into the "Vehicles it fits" section to see whether this arm matches.
Fit and size
Build and materials
One lateral arm with its rubber bushings. Mounting hardware, a ball joint and a grease fitting are not included, so plan on new fasteners rather than reusing the old ones.
Interchange: 102-7562
TC2453 · CA12144 · CA4631 · 2CB10217 · RK641153 · GS70148 · CMS70148 · 2606436 · 1526010 · 1526052 · X01CA0694 · JTC2105 · 8K0407152D · V101872 · 8K0407152B · 8K0407152C
This part cross-references / interchanges with the following part numbers:
Is the Dorman 521-256 front right lower arm right for a 2009-2012 Audi A4?
Yes. Dorman 521-256 is the front right lower lateral arm for the 2009-2012 Audi A4. The front left is a separate part.
Do these lateral arms come with bushings and a ball joint?
The rubber bushings are included with the arm. The ball joint, mounting hardware and grease fitting are not included.
What size are the bushings on the Dorman 521-256 arm?
Dorman 521-256 has a bushing inside diameter of 14.3 mm, an outside diameter of 39.6 mm and a bushing length of 92 mm.
What is this lateral arm made of, and what finish does it have?
The control arm is aluminum with a powder-coated finish, in casting/forged construction.
What does a worn lateral arm look like on inspection?
Cracked or torn bushing rubber or a bent arm can mean the arm is worn. A shop can test the arm and its bushings for play.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.