Keep your rear disc brakes seated, quiet, and moving freely with the Dynamic Friction Company Disc Brake Hardware Kit (P/N 340-13017, also written 34013017). This DFC hardware kit is a direct-fit replacement for the rear brakes on the 2005-2009 Subaru Legacy — see the Buyer's Guide tab for engine-level fitment. It refreshes the clips, springs, and retaining pieces that locate the pads and let them slide as they should, so a new set of pads goes in on fresh, correct hardware instead of worn, rusted originals.
Chemical resistance rounds out the design to help the hardware hold up in the harsh under-car environment. If worn or seized hardware is behind rear pad noise, uneven wear, or dragging, replacing it with this kit addresses that cause. It's a smart addition whenever you install new rear pads on the listed applications.
What is a disc brake hardware kit?
It's the set of clips, springs, and retaining pieces that locate the brake pads and let them slide correctly. This kit replaces those worn rear-brake components when you service the brakes.
Does this kit fit my vehicle?
It's cataloged as a rear disc brake hardware kit for the 2005-2009 Subaru Legacy. Check the Buyer's Guide tab to confirm the exact application for your vehicle.
Is this for the front or rear brakes?
The catalog lists this kit for the REAR disc brakes.
Should I replace hardware when I install new pads?
It's a good practice. Fresh hardware helps new pads seat and slide properly, which can reduce noise, bind, and uneven wear from old, corroded pieces.
Are brake pads included in this kit?
No. This is a hardware kit containing the clips, springs, and retaining pieces; brake pads are purchased separately.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
