Get the rotors, pads and hardware for your brake job in one box with the DYNAMIC FRICTION brake kit 4514-67052 (also written 451467052). This front and rear disc brake kit is a direct-fit replacement for the 2007-2011 Nissan Altima, pairing DFC GEOSPEC Coated Rotors with DFC 5000 ceramic pads and the matching disc-brake hardware so you can service both axles at once.
GEOSPEC Coated Rotors: cast to the G3000/G11H18 iron specification and finished with a special silver-gray coating that fights rust better than conventional paint or zinc coatings. Each rotor is machined to a non-directional finish to promote faster, more even pad bed-in and smoother stops, and ships dry and ready to install with no pre-degreasing.
DFC 5000 Ceramic Pads: 100% asbestos-free and post-cured, then scorched to reduce the initial break-in period. Assembled with Premium Rubber-Steel-Rubber shims for improved NVH, they are designed to deliver a consistent pedal feel and brake response.
Hardware Kit: includes stainless steel components and rubber-coated abutment clips designed with the same attention to form, fit, and function as OE manufacturers to help reduce noise, vibration and premature wear.
Chamfered and slotted where applicable to reduce braking noise.
What does the DYNAMIC FRICTION brake kit 4514-67052 include?
It's a complete front and rear kit with DFC GEOSPEC Coated Rotors, DFC 5000 ceramic pads, and the matching disc-brake hardware, so you can service both axles at once.
Is this a 2007-2011 Nissan Altima brake kit?
Yes. This kit is a direct-fit replacement for the 2007-2011 Nissan Altima; see the Buyer's Guide tab for the full fitment details.
What are the benefits of the ceramic pads in this brake kit?
The DFC 5000 asbestos-free ceramic pads are designed to deliver a consistent pedal feel and brake response, with Rubber-Steel-Rubber shims for improved NVH.
What is the GEOSPEC coating on the rotors?
It's a special silver-gray finish applied to the rotors that fights rust better than conventional paint or zinc coatings. The rotors ship dry and are ready to install with no pre-degreasing.
Do the rotors need any preparation before installing?
No. Each GEOSPEC Coated Rotor is processed dry, shipped dry, and ready to install without additional degreasing—the coating is swept away by the friction material.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
