Delphi FE0065 electric fuel pump for the 1985-1988 Ford Ranger 4-cylinder 2.3L, the 1986-1988 Ranger V6 2.9L and other vehicles sits in the fuel tank and sends fuel to the engine.
- Designed to run under extreme temperatures with quick engine starts
- Pump design for fast pressure performance with less energy
- Lower amperage draw puts less load on the vehicle's electrical system
- Validated, tested and matched to the right application
Quick facts
- Part: Delphi FE0065 electric fuel pump
- Fits: the 1985-1988 Ford Ranger 4-cylinder 2.3L, the 1986-1988 Ranger V6 2.9L and other vehicles
- Position: In-tank
- Condition: New
A fuel pump that is wearing out can show up as hard starting, sputtering or stalling, or a whine from the tank. Other parts can produce those signs as well, so with the engine off and cool, look over the fuel pump fuse, relay and wiring connector for damage first. If the pump is the cause, this one replaces it.
Fits
This in-tank pump fits the 1989-1991 Ford E-350 Econoline 6-cylinder 4.9L or V8 5.8L, the 1990-1991 E-350 Econoline V8 7.5L and the 1989 Ford E-350 Econoline Club Wagon 6-cylinder 4.9L, V8 5.8L or 7.5L, with one pump going in per vehicle. If your vehicle is not named here, look up your year, model and engine in the "Vehicles it fits" section.
Specifications
Fit and size
- Position: In-tank
- Quantity per vehicle: 1
Build and materials
- Type: Electric fuel pump
- Condition: New
In the box
One electric fuel pump, two hose clamps, one hose piece, one isolator, two seals and one instruction sheet.
Installation notes
- Check and clean the fuel tank before the new pump goes in.
- Replace the fuel strainer whenever the fuel pump is replaced.
- The instruction sheet in the box covers the steps.
Frequently Asked Questions
Does the Delphi FE0065 fit the 1986-1988 Ford Ranger V6 2.9L?
Yes. Delphi FE0065 fits the 1986-1988 Ford Ranger V6 2.9L, and one pump goes in per vehicle.
Do the hose clamps and seals come with the FE0065 fuel pump?
Yes. Delphi FE0065 comes with two hose clamps, a hose piece, an isolator, two seals and an instruction sheet along with the pump.
Is the Delphi FE0065 an in-tank or inline fuel pump?
It is an in-tank pump. This fuel pump has an in-tank position, so it goes inside the fuel tank.
Could a whine from the tank mean this fuel pump is wearing out?
It can. A whine from the tank, hard starting or stalling can mean a tired pump, and a shop can test fuel pressure to confirm.
Should I change the fuel strainer when installing the FE0065?
Yes. A fuel pump repair calls for a new fuel strainer, and the tank should be checked and cleaned beforehand.
