Restore a controlled, settled ride at the rear of your Mitsubishi Lancer with the Focus Auto Parts Suspension Strut and Coil Spring Assembly (P/N 1345830). This is a rear, pre-assembled strut and coil spring unit that installs as a direct-fit replacement for the 2008-2017 Mitsubishi Lancer — see the Buyer's Guide tab for engine-level fitment.
- Pre-assembled unit: combines the strut and coil spring into one ready-to-install assembly, simplifying the rear suspension job.
- Rear position: cataloged for the rear of the vehicle, where it helps support the body, damp spring oscillation, and locate the wheel.
- Damping and support: the strut controls suspension movement while the coil spring carries load, helping maintain ride height and tire contact with the road.
A worn strut or fatigued spring can show up as a bouncy or wallowing ride, excessive body movement over bumps, uneven tire wear, or noise from the rear suspension. If a failed rear strut and spring on your Lancer is the cause, this assembly replaces it. Struts and springs work as a pair across the axle — replacing both sides together helps keep ride height and handling balanced and even.
Frequently Asked Questions
What vehicles does this assembly fit?
It is a direct-fit rear replacement for the 2008-2017 Mitsubishi Lancer. Check the Buyer's Guide tab to confirm the exact fit for your vehicle.
Is this a front or rear unit?
It is cataloged as a rear suspension strut and coil spring assembly.
Does it come pre-assembled?
Yes. The strut and coil spring are combined into one ready-to-install unit, which simplifies installation.
Should I replace both sides at once?
Struts and springs work as a pair across the axle, so replacing both sides together helps keep ride height and handling balanced and even.
What are signs this assembly may need replacing?
A bouncy or wallowing ride, excessive body movement over bumps, uneven tire wear, or noise from the rear suspension. Diagnose the cause before replacing.
Write a Review