Heater Hose for 2007-2013 BMW 328i & More - Gates 51738

Be the first to review this product

$62.99

MPN: 51738

UPC: 770075795964

Item Package Quantity: 1

Current Stock:

Quantity:

Adding to cart… The item has been added

Have questions?

Ask an Expert

Gates HVAC Heater Hose P/N:51738

$62.99

Description

Keep coolant moving between the water pump and thermostat with the Gates Molded Coolant Hose 51738, a pre-shaped direct-fit replacement listed under both the coolant hose and HVAC heater hose part types. It's cataloged for the water pump-to-thermostat position on many BMW models, among them the 2007-2013 BMW 328i, 2008-2013 BMW 128i and 2009-2013 BMW 328i xDrive. See the Buyer's Guide tab for the full application and engine list.

Gates pre-shapes each hose to fit and to help ensure a properly sealed connection.

EPDM construction: EPDM tube with synthetic fiber knit reinforcement and a heat-, ozone- and chemical-coolant-resistant EPDM cover.
Collapse resistant: specifically-engineered materials help resist collapse under vacuum.
Degradation resistant: engineered to resist electrochemical degradation, the leading cause of hose failure.
Pre-shaped fit: pre-shaped to fit for a properly sealed connection.

Meets the requirements of SAE 20R4, class D2 and DIN 73411, class A (except for tolerances), with a temperature range of -40°F to +257°F (-40°C to +125°C). Do not use for fuel or oil transfer applications. Gates recommends replacing the hose clamps each time a new coolant hose is installed.

Interchange: 20850S · 11537521049 · F10414 · R19568 · CHE0409 · CHE0497

Manufacturer's Description

Product Specs

Buyer's Guide

Interchange Part Numbers

This part cross-references / interchanges with the following part numbers:

20850S, 11537521049, F10414, 51738, R19568, CHE0409, CHE0497

Frequently Asked Questions

Where does this hose install?

It's cataloged for the water pump-to-thermostat coolant connection on the listed BMW applications. Check the Buyer's Guide tab to confirm the correct hose for your vehicle.

What is the hose made of?

An EPDM tube with synthetic fiber knit reinforcement and a heat-, ozone- and chemical-coolant-resistant EPDM cover, engineered to resist collapse under vacuum and electrochemical degradation.

Is the hose pre-shaped?

Yes. Gates pre-shapes it to fit the listed applications and to help ensure a properly sealed connection. Confirm your model and year in the Buyer's Guide tab.

Should I replace the hose clamps too?

Gates recommends installing new hose clamps each time a coolant hose is replaced to help ensure a properly sealed connection.

Can I use this hose for fuel or oil lines?

No. This is a coolant hose only. Gates cautions against using it for fuel or oil transfer applications.