LuK Clutch Flywheel P/N:LFW282
Give a new clutch a smooth, flat surface to engage against with the LuK Clutch Flywheel LFW478, a new rigid flywheel and a practical alternative to resurfacing the old one. It is a direct-fit replacement for the 2012-2017 Jeep Wrangler and the 2018 Jeep Wrangler JK with the V6-3.6L engine, and each vehicle uses one.
A flywheel bolts to the crankshaft, gives the clutch disc its friction surface, and carries the ring gear that the starter engages. This flywheel comes with dowel pins. Replacing the flywheel with a new one when you install a clutch set is a cost-effective alternative to resurfacing the original.
Specifications: friction surface OD 290 mm (11.417 in) and ID 193 mm (7.598 in); outside diameter 326.35 mm (12.848 in); ring gear mounting OD 294.3 mm (11.587 in); ring gear thickness 10.15 mm (0.400 in); flywheel thickness 36.45 mm (1.435 in); crank to friction surface 41.87 mm (1.648 in); pilot I.D. 25.2 mm (0.992 in); crankshaft bolt-hole PCD 73 mm (2.874 in); pressure plate bolt-hole PCD 304 mm (11.969 in); dowel hole diameter 6 mm (0.236 in); flange thickness 25 mm (0.984 in). Country of origin: Thailand.
Signs a flywheel may need replacing include clutch chatter or judder on engagement, vibration, a scored or heat-spotted friction surface, and damaged ring gear teeth that grind during starting. Diagnose the cause before replacing any parts. Consult the vehicle service information for the correct fasteners and whether they may be reused.
Interchange: 51844-38AB
5184438AB · 4160316100
This part cross-references / interchanges with the following part numbers:
What vehicles does the LuK LFW478 flywheel fit?
It fits the 2012-2017 Jeep Wrangler and the 2018 Jeep Wrangler JK with the V6-3.6L engine. Each vehicle uses one flywheel.
What part numbers does LFW478 cross-reference to?
It cross-references to 51844-38AB (also listed as 5184438AB) and 4160316100.
Does it come with dowel pins and a ring gear?
Yes. It comes with dowel pins. Its 127-tooth ring gear is made to OE specifications, and the ring gear chamfer matches OE.
Why replace the flywheel instead of resurfacing it?
LuK presents a new flywheel as a cost-effective alternative to resurfacing. It gives the new clutch a smooth, flat friction surface to engage against.
What are signs a flywheel may need replacing?
Clutch chatter or judder, vibration, a scored or heat-spotted friction surface, or damaged ring gear teeth can indicate a worn flywheel. Diagnose the cause before replacing any parts.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.