Replace a worn front driver's-side corner with the Mevotech Supreme control arm CMS25142, a direct-fit replacement for the 2005-2010 Dodge Dakota, 2006-2009 Mitsubishi Raider, and 2011 Ram Dakota. This front left lower control arm and ball joint assembly locates the wheel hub, connects it to the frame, and the integrated ball joint lets the suspension travel and steer. See the Buyer's Guide tab for engine-level fitment.
Built to OE-level tolerances with cast steel construction, this Mevotech Supreme suspension control arm carries a protective surface treatment that helps resist corrosion. If clunking over bumps, loose or wandering steering, or uneven tire wear traces to a failed arm or ball joint, this Dodge Dakota lower control arm replaces the front left lower unit. Sold individually for the front left lower position; order the opposite side separately for a balanced set.
Interchange: 101-7043 · 102-7043 · 622.67022 · 521-147
1017043 · 1027043 · 62267022 · 521147 · 19290008 · 52855107AA · 52855107AB · TC5991 · CB81063 · CB81063PR · CA12408 · CAK620478 · K620478 · RK620478 · FA4955 · 30030738 · 5CB25082 · 5071533 · SRK620478 · X13CJ0576 · JTC2338 · CP5012 · TK620478
This part cross-references / interchanges with the following part numbers:
What vehicles does this Dodge Dakota control arm fit?
It is a direct-fit front left lower replacement for the 2005-2010 Dodge Dakota, 2006-2009 Mitsubishi Raider, and 2011 Ram Dakota. Check the Buyer's Guide tab to confirm your exact application.
Is the ball joint already installed on this control arm?
Yes. The ball joint is pre-installed in the cast steel arm, and it comes with a 90-degree SAE grease fitting and a part-specific nylon locking nut for installation.
What are signs I need a new 2005 Dodge Dakota control arm?
Clunking over bumps, loose or wandering steering, and uneven tire wear can point to a worn control arm or ball joint. Diagnose the cause first, since these symptoms can have other sources.
Which side of the vehicle does this fit?
It fits the front left (driver's-side) lower position. It is sold individually, so order the opposite-side arm separately if you want to replace both sides together.
Is this control arm greaseable?
Yes. It comes with a 90-degree SAE grease fitting, allowing the ball joint to be lubricated during service.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
