Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS401296
$244.99
(You save)
Keep the front right lower wheel located and your steering tight with the Mevotech Supreme Control Arm with Ball Joint CMS401296 — a direct-fit F-150 control arm for the 2021-2025 Ford F-150. It ships with the ball joint pre-assembled into the front right lower arm, so a worn arm and a tired joint go back in as one bolt-in unit.
Mevotech Supreme parts are engineered in-house with application-specific upgrades for high-usage commercial and passenger trucks, SUVs and fleets, plus Labor Saver designs that make the install faster.
Faster installation: the ball joint is pre-assembled for a complete solution.
Superior toughness: sintered bearings for longer-lasting performance.
Increased stiffness: bushings upgraded with a double bonded design and added knurling for added stiffness and durability.
Simple to service: a 90-degree SAE grease fitting is included, and the ball joint's thicker, stronger flange helps prevent deformation during installation, with a part-specific nylon locking nut provided.
Built from stamped steel to OE-level tolerances, this Mevotech Supreme suspension control arm is a bolt-in replacement for a worn front right lower control arm and ball joint assembly.
Which vehicles does the CMS401296 control arm fit?
It's a direct-fit Ford F-150 control arm for the 2021-2025 Ford F-150. See the Buyer's Guide tab to confirm your exact engine and trim.
What position on the truck does this control arm cover?
It replaces the front right lower control arm, with the ball joint pre-assembled into the arm for a complete corner in one unit.
Is the ball joint included?
Yes. The ball joint is pre-assembled into the arm, and a part-specific nylon locking nut is provided to speed the ball joint installation.
Can I grease this Mevotech Supreme control arm?
Yes. It includes a 90-degree SAE grease fitting so you can service the joint, and it runs on sintered bearings for longer-lasting performance.
What is this control arm made of?
It uses stamped steel construction built to OE-level specifications, with bushings upgraded using a double bonded design and added knurling for increased stiffness.
Write a Review
Mevotech Supreme
Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS401296
Bring the front suspension of your 2012-2017 Fiat 500 back to spec with the Mevotech Supreme control arm and ball joint assembly, MPN CMS101183. This is the front left (driver's side) lower unit,...
Get tight, controlled handling back with the Mevotech Supreme control arm and ball joint assembly (CMS86139) — a front right lower unit that installs as a direct-fit replacement for the 2006-2019...
Keep your front suspension tight and your steering response sharp with the Mevotech Supreme control arm, part number CMS901259. This front right lower control arm and ball joint assembly installs as...
Keep your front-end geometry tight and steering precise with the Mevotech Supreme control arm CMS101632, a direct-fit front left upper control arm with an integrated ball joint for the 2019-2024...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
