Mevotech TTX Suspension Control Arm and Ball Joint Assembly P/N:CTXMS251268
$148.99
(You save)
Tighten up a loose, clunky front end with the Mevotech TTX Control Arm and Ball Joint Assembly (CTXMS251268) — a front right upper Ram 1500 upper control arm built for high-usage commercial and passenger trucks, SUVs and fleets. It's a direct-fit replacement for the 2019-2025 RAM 1500, plus the 2022-2024 JEEP GRAND WAGONEER and JEEP WAGONEER, and the 2023-2024 JEEP GRAND WAGONEER L and JEEP WAGONEER L. See the Buyer's Guide tab for the full list.
This TTX-series arm positions the wheel and carries the integrated ball joint, so it addresses worn bushing and ball-joint wear in one bolt-on assembly.
Cast steel construction: Upgraded with a filled-in hole/recess and reinforced ball joint head for added durability.
Patented sintered bearings: Engineered for longer-lasting performance.
Sealed ball joint: A patented sealing ring permanently locks the boot onto the ball joint housing to help keep out contaminants.
Upgraded bushings: A solid cross section with added knurling boosts stiffness and durability.
Serviceable design: Includes a 180-degree SAE grease fitting, plus a part-specific slotted castle nut and snap cotter pin for installation.
Finished with Repel-TEK surface treatment to help resist rust build-up.
It's a front right upper control arm and ball joint assembly that locates the wheel and carries the integrated ball joint as a single bolt-on unit.
Which vehicles does it fit?
It's a direct-fit replacement for the 2019-2025 RAM 1500, 2022-2024 Jeep Grand Wagoneer and Wagoneer, and 2023-2024 Jeep Grand Wagoneer L and Wagoneer L. See the Buyer's Guide tab.
Is this an upper or lower control arm?
The catalog lists this as the front right upper position. Confirm the correct side and location for your specific vehicle in the Buyer's Guide.
Is mounting hardware included?
Yes. It comes with a part-specific slotted castle nut and easy snap cotter pin for the ball joint, plus a 180-degree SAE grease fitting for servicing.
What are signs the control arm or ball joint may need replacing?
Clunking over the front end, loose or wandering steering, and uneven tire wear can point to a worn ball joint or bushing. Diagnose the cause; if this arm is at fault, it replaces it.
Write a Review
MEVOTECH
Mevotech TTX Suspension Control Arm and Ball Joint Assembly P/N:CTXMS251268
Mevotech TTX Suspension Control Arm and Ball Joint Assembly P/N:CTXMS251269. Fits: Jeep Grand Wagoneer, Jeep Grand Wagoneer L, Jeep Wagoneer, Jeep Wagoneer L, Ram 1500.
Rebuild the front end with the Mevotech TTX control arm CTXMS501233, a front right upper control arm and ball joint assembly engineered for high-usage commercial and passenger vehicles, SUVs, fleets...
Steer with confidence on the Mevotech TTX control arm and ball joint assembly, MPN CTXMS501335 — a front left lower unit that locates the wheel and pivots the steering knuckle on the ball joint. It...
Keep your front suspension tight and steering precise with the Mevotech TTX control arm, part number CTXMS501355 — a front upper control arm and ball joint assembly built as a direct-fit replacement...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
