Mevotech TTX Suspension Control Arm and Ball Joint Assembly P/N:CTXMS401296
$318.99
(You save)
Keep your front suspension properly located and control ride movement with the Mevotech TTX Suspension Control Arm and Ball Joint Assembly CTXMS401296 — a direct-fit F-150 control arm for the 2021-2025 Ford F-150. It installs in the front right lower position and ships as a complete corner solution, so worn factory geometry, clunks, or looseness can be addressed in one part.
Built for high-usage passenger, fleet and work-truck duty, this control arm and ball joint assembly pairs a rugged build with time-saving install features:
Faster installation: the ball joint arrives pre-assembled to the arm for a ready-to-bolt-in unit.
Increased stiffness: double-bonded, knurled bushings add stiffness and durability to help handling.
Stronger build: a stamped steel control arm with a reinforced ball joint head, riding on patented sintered bearings for long-lasting performance.
Simple to service: a boot built into the ball joint seals out corrosion, and an included 180-degree SAE grease fitting makes lubrication easy.
Secure the ball joint with the part-specific slotted castle nut and easy snap cotter pin provided. Consult the vehicle service information for the correct fasteners and torque.
Interchange: 19531510 · ML3Z3078E
This part cross-references / interchanges with the following part numbers:
19531510, ML3Z3078E, CTXMS401296
Frequently Asked Questions
Which vehicle does this Ford F-150 control arm fit?
It is a direct-fit replacement for the 2021-2025 Ford F-150, installing in the front right lower position. See the Buyer's Guide tab to confirm your exact configuration.
Is this a Mevotech TTX lower control arm with the ball joint included?
Yes. It is a front right lower control arm and ball joint assembly with the ball joint pre-assembled to the arm, so you replace both together in one unit.
What hardware comes with this assembly?
It includes a part-specific slotted castle nut and easy snap cotter pin to secure the ball joint, plus a 180-degree SAE grease fitting for servicing.
What are the signs this control arm may need replacing?
Clunking or knocking over the front suspension, loose or wandering steering, uneven tire wear, or a cracked/torn ball joint boot can indicate a worn arm or ball joint. Diagnose the cause before replacing.
What interchange numbers does this part replace?
It cross-references 19531510 and ML3Z3078E. Match your original part number and application before ordering.
Write a Review
Mevotech TTX
Mevotech TTX Suspension Control Arm and Ball Joint Assembly P/N:CTXMS401296
Bring back tight, controlled steering on the front-right corner with the Mevotech TTX control arm and ball joint assembly (P/N CTXMS501118). This front right lower unit drops in as a direct-fit...
Help keep the front suspension located and the wheel under control with the Mevotech TTX control arm, part number CTXMS25117. This forged steel front left upper arm pairs the arm with its ball joint...
Dial in tight, controlled steering with the Mevotech TTX control arm and ball joint assembly (CTXMS20328), a heavy-duty replacement for the front right (passenger-side) lower position. This complete...
Refresh the front end of your minivan with the Mevotech TTX control arm CTXMS251240, a front left lower control arm and ball joint assembly engineered as a direct-fit replacement for the 2017-2025...
Keep your front suspension tight and steering predictable with the Mevotech TTX Control Arm and Ball Joint Assembly CTXK8708T, a front left upper Ford Ranger control arm that also drops in as a...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
