Help keep steering input precise with the Mevotech TTX Tie Rod End TXMS30624, a front right outer steering tie rod end that connects the tie rod to the steering knuckle and passes steering motion to the wheel. It fits many vehicles, among them the 2013-2019 Nissan Sentra, 2020 Nissan Versa and 2011-2025 Nissan Leaf. See the "Vehicles it fits" section for the full list.
Mevotech builds its TTX line for high-usage commercial and passenger vehicles, SUVs, fleets and working trucks. Its Labor Saver designs, tools and hardware are intended to make installation faster and easier.
- Maximum toughness: patented sintered bearings are designed for longer-lasting performance.
- Locks out contaminants: a patented sealing ring locks the boot onto the ball joint housing to help keep the seal intact.
- Larger sphere design: an application-specific ball stud system uses a larger sphere.
- A stronger bond: pre-applied nylok thread adhesive helps keep fasteners secure and resists vibration.
A part-specific slotted castle nut and an easy snap cotter pin come in the box to secure the joint to the vehicle. A 180 degree SAE grease fitting is also included for servicing.
Signs a tie rod end may need replacing include loose or wandering steering, a clunk or knock when turning, uneven front tire wear and a torn boot. If a worn front right outer tie rod end is the cause, this unit is a direct-fit replacement for the listed applications. A wheel alignment check after installation is recommended.
Product information is for general reference and may contain errors. See our Disclaimer.
Frequently Asked Questions
Is this the right tie rod for a 2013-2019 Nissan Sentra?
It is listed for the 2013-2019 Nissan Sentra, and it also fits the 2020 Nissan Versa and 2011-2025 Nissan Leaf. Check the "Vehicles it fits" section to confirm your exact vehicle.
Which position does TXMS30624 install in?
It is cataloged as the front right outer tie rod end. It connects the tie rod to the steering knuckle.
What hardware comes with this tie rod end?
It includes a part-specific slotted castle nut, an easy snap cotter pin and a 180 degree SAE grease fitting. The fasteners have nylok thread adhesive pre-applied.
Can this tie rod end be greased?
Yes. The included 180 degree SAE grease fitting allows the joint to be serviced with grease.
What are the signs of a worn tie rod end?
Common signs include loose or wandering steering, a clunk when turning, uneven tire wear and a torn boot. Diagnose the cause before replacing, and check the alignment afterward.
