MOOG Chassis Products Suspension Control Arm and Ball Joint Assembly P/N:RK621967
Tighten up a loose, clunking front end with the MOOG Chassis Products Front Left Upper Suspension Control Arm and Ball Joint Assembly (RK620172) — a direct-fit S10 control arm that installs in the front left upper position on the 1984-2004 Chevrolet S10 and drops in the same way on the 1995-2005 Chevrolet Blazer, 1992-2005 GMC Jimmy, GMC Sonoma and more. This one-piece assembly locates the wheel through its suspension travel while the integrated, greaseable ball joint carries the steering motion.
Clunking over bumps, wandering steering, uneven tire wear or a loose feel are signs the original front left upper arm or ball joint may need replacing; if a worn arm assembly is the cause, this replaces it.
Fitment: 1984-2004 Chevrolet S10, 1984-1994 Chevrolet S10 Blazer, 1995-2005 Chevrolet Blazer, 1992-2005 GMC Jimmy, 1984-1990 GMC S15, 1984-1991 GMC S15 Jimmy, 1991-2004 GMC Sonoma, 1991 GMC Syclone, 1992-1993 GMC Typhoon, 1998-2000 Isuzu Hombre, and Oldsmobile Bravada (1991-1994 and 1996-2001). See the Buyer's Guide tab for engine-level fitment.
Interchange: 810-95138B · 622.66018 · 520-139 · 260-5330 · 260-5539 · 502-1100 · 502-1140
81095138B · 62266018 · 520139 · 2605330 · 2605539 · 5021100 · 5021140 · 45D1140 · TC5445 · CB90157PR · CA10252 · 1566150000000000 · 15661507 · 93213428 · 8156615070 · CB90157 · FA4435 · CMS20354 · MS20354 · 109620172 · JTC1519
This part cross-references / interchanges with the following part numbers:
What is this MOOG RK620172 part?
It is a front left upper control arm with an integrated ball joint — the arm and its greaseable ball joint in one unit, ready to bolt in with the included hardware.
Does this fit a Chevrolet Blazer control arm application?
Yes. It is cataloged for the front left upper position on the 1995-2005 Chevrolet Blazer, along with the S10, GMC Jimmy, Sonoma and other listed models. Check the Buyer's Guide tab for your year and engine.
Does it come with the ball joint and mounting hardware?
Yes. The ball joint is integrated into the assembly, and MOOG includes all necessary hardware for installation.
Can I grease this control arm?
Yes. It uses a greaseable socket, so you can add fresh lubricant to flush out contaminants and reduce corrosion and wear.
What are the signs my front left upper arm needs replacing?
Clunking over bumps, wandering or loose steering, and uneven tire wear can indicate a worn control arm or ball joint. Diagnose the cause first; if this arm is at fault, RK620172 replaces it.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.