Guaranteed to Fit Convenient vehicle selection
Fast Shipping Get the part when you need it
Hassle-Free Returns Simple & convenient online returns
Track Your Order See where your package is
Guaranteed to Fit
Fast Shipping
Hassle-Free Returns
MOOG Chassis Products Suspension Control Arm and Ball Joint Assembly P/N:RK80406
MSRP:
$85.99
Save
$85.99
Replace a worn or bent 2000-2004 Ford Focus control arm with the MOOG Chassis Products Suspension Control Arm and Ball Joint Assembly RK80406. It drops in as a direct-fit replacement for the front left lower position on the 2000-2004 Ford Focus, locating the suspension and providing the ball-joint pivot for the wheel.
Carbon fiber bearings: Induction-hardened studs paired with a patent-pending carbon fiber-reinforced bearing reduce socket friction versus non-reinforced bearings for longer socket life.
Precise engineering: Optimized bushings for quiet operation and resistance to wear, salt, road grime and oils.
Corrosion protection: Coated studs plus an e-coated cast iron and steel arm inhibit premature deterioration, and it's heat treated to match or exceed OE requirements.
Install ready: Ships with a pre-installed ball joint featuring a greaseable socket, laser-etched MOOG ID, and all necessary hardware for a fast fit.
As a front lower unit, this is the 2000-2004 Ford Focus lower control arm for the front left corner. It's sold individually; replacing the opposite side at the same time is recommended for even wear and handling.
Frequently Asked Questions
What does the MOOG RK80406 control arm and ball joint assembly do?
It locates the front suspension and provides the ball-joint pivot for the wheel, combining the control arm and a pre-installed ball joint into one bolt-in assembly.
Does the RK80406 fit my 2000-2004 Ford Focus?
It's a direct-fit replacement for the front left lower position on 2000-2004 Ford Focus models. Check the "Vehicles it fits" section to confirm your exact vehicle.
Is mounting hardware included?
Yes. This assembly comes with all necessary hardware for installation. An alignment is recommended after fitting suspension components.
Is the ball joint pre-installed and can it be greased?
The ball joint comes pre-installed, and it uses a greaseable socket that lets new lubricant flush out contaminants to reduce corrosion and wear.
Do I need to replace the other side too?
This is a left front lower arm sold individually. Replacing the matching right-side arm at the same time helps keep suspension wear and handling balanced, but it isn't required.
Reviews
No reviews yet — be the first to review this product.
MOOG RK621782 Front Upper Suspension Control Arm and Ball Joint Assembly for Chevrolet Silverado 1500Front Upper Suspension Control Arm and Ball Joint AssemblyMOOG premium control arms for foreign...
MOOG RK621538 Front Right Upper Suspension Control Arm and Ball Joint Assembly for Chrysler 300Front Right Upper Suspension Control Arm and Ball Joint AssemblyMOOG premium control arms for foreign...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
