MOOG LK134 rear right suspension knuckle assembly for the 2003-2008 Subaru Forester carries the wheel bearing and hub together in one pre-assembled unit. Instead of pressing a new bearing into the old knuckle, you bolt on the whole assembly.
- Bolt-on, pre-assembled design that removes the need for special tools or a press
- E-coated backing plate and knuckle for corrosion resistance
- Tested by MOOG engineers throughout design and development
Quick facts
- Part: MOOG LK134 suspension knuckle assembly
- Also called: wheel bearing and hub assembly
- Fits: 2003-2008 Subaru Forester
- Position: Rear right
- Condition: New
A humming or growling noise that changes with road speed, or play at the wheel, can mean this assembly is worn, though an uneven tire or a worn brake rotor can also bring on noise or vibration, so find the source before replacing it.
Fits
For a bearing replacement on the 2003-2008 Subaru Forester, the rear right takes one assembly. The rear left is a separate part ordered separately, and both sides are normally replaced together.
Specifications
Fit and size
- Position: Rear right
- Quantity per application: 1 (rear right side only)
Build and materials
- Type: pre-assembled, bolt-on knuckle assembly
- Corrosion protection: e-coated backing plate and knuckle
- Condition: New
- Country of origin: China
In the box
One pre-assembled knuckle assembly with the MOOG knuckle, wheel hub with studs, bearing, axle nut and backing plate, plus a ball joint where applicable.
Interchange: 698-416
28419FE001
Product information is for general reference and may contain errors. See our Disclaimer.
Frequently Asked Questions
Is this the rear wheel bearing for the 2003-2008 Subaru Forester?
Yes. MOOG LK134 is the rear right knuckle assembly for the 2003-2008 Subaru Forester, and the wheel bearing comes already installed in it. The rear left is ordered separately.
Does this wheel bearing and hub assembly include the axle nut and studs?
Yes. MOOG LK134 comes pre-assembled with the knuckle, wheel hub with studs, bearing, axle nut and backing plate, plus a ball joint where applicable.
Do I need a press to install the MOOG LK134 knuckle assembly?
No. Its bolt-on, pre-assembled design is meant to remove the need for special tools or a press when replacing the bearing.
Can I use LK134 for a rear wheel bearing replacement on the left side of a 2003-2008 Subaru Forester?
No. LK134 is the rear right assembly. The rear left side is a separate part and is ordered separately.
Is the knuckle on this rear knuckle assembly coated against rust?
Yes. The backing plate and the knuckle on MOOG LK134 are e-coated for corrosion resistance.
