NTK Engine Coolant Temperature Sensor P/N:EF0157
NTK EF0171 coolant temperature sensor for the 2004-2010 Ford E-350 Super Duty V8 6.0L and other vehicles reports engine coolant temperature to the ECM as an analog signal. The ECM uses it for the air/fuel ratio, cooling fan(s) and temperature gauge.
This engine coolant temperature sensor may sit on the cylinder head, engine block, thermostat housing or intake manifold. A check engine light, an erratic or dead temperature gauge or overheating can be linked to a failing sensor. Before replacing it, look over the sensor, its connector and its wiring with the engine off and cool for damage or coolant seepage. If the sensor is the cause, this one replaces it. This listing is one sensor, and each engine takes one.
This sensor is listed for a wide range of Ford models, led by the 2003-2007 Ford F-250 Super Duty V8 6.0L and the 2008-2009 F-250 Super Duty V8 6.4L. Wire and probe length match OE. For another truck, look up its year and engine in the "Vehicles it fits" section.
One coolant temperature sensor. Mounting clip(s) are included where applicable.
Interchange: 3C3Z-10884-AA · TS-603
WT7252 · HTS125 · TS7252 · 2CTS0219 · SW6052
This part cross-references / interchanges with the following part numbers:
Does the NTK EF0171 fit a 2004-2010 Ford E-350 Super Duty V8 6.0L?
Yes. The NTK EF0171 is listed for the 2004-2010 Ford E-350 Super Duty V8 6.0L, and that engine takes one sensor.
Is the NTK EF0171 right for the 2008-2009 Ford F-250 Super Duty V8 6.4L?
Yes. The NTK EF0171 is listed for the 2008-2009 Ford F-250 Super Duty V8 6.4L, with one sensor per engine.
What is inside the housing of this coolant temperature sensor?
Thermal conductive grease sits inside the brass housing. It shortens response time and carries temperature to the thermistor for accurate readings.
Can a bad coolant temperature sensor affect the cooling fan?
Yes, a failing sensor can be linked to cooling fan problems. An erratic or dead fan, an erratic gauge, a check engine light or overheating are reasons to replace it, and a shop can test the sensor.
Does the NTK EF0171 come with a mounting clip or o-ring?
Mounting clip(s) are included where applicable. Thread sealant or an o-ring is installed on the sensor where applicable.
Published by the manufacturer of this part. Links open in a new tab.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.