Nugeon 99-00632A front left brake caliper for the 2008-2011 Nissan Versa clamps the brake pads against the rotor to slow the wheel. This remanufactured Nugeon brake caliper is a floating type.
- Single 54 mm steel piston
- Cast iron casting with a rust preventative finish
- Mounting bracket, caliper slides and dust boots included
- Bleeder screw and crush washers included
- Banjo bolt inlet fitting with an M10-1.0 x 23.4 mm port thread
Quick facts
- Part: Nugeon 99-00632A brake caliper
- Also called: disc brake caliper
- Fits: 2008-2011 Nissan Versa
- Position: Front left
- Material: Cast iron
- Condition: Remanufactured
A pull to one side, a dragging wheel or fluid around the dust boot can point to a sticking piston or slide. With the engine off, look for damp fluid at the boot and compare pad wear side to side before you replace anything, since a worn pad or a brake hose may show similar symptoms. If the caliper is the cause, this one replaces it.
Fits
This caliper is a direct-fit replacement for the 2008-2011 Nissan Versa, with the L4-1.6L listed for 2009-2011. There is one caliper on each side of the front axle. This listing is the front left, the front right is a separate part ordered on its own, and both front calipers are normally replaced together.
Specifications
Fit and size
- Position: Front left
- Quantity per application: 1
- Piston quantity: 1
- Piston diameter: 54 mm (2.126 in)
- Bleeder screw thread: M7-1.0
- Inlet port thread: M10-1.0 x 23.4 mm
Build and materials
- Caliper type: Floating
- Condition: Remanufactured
- Casting material: Cast iron
- Piston material: Steel
- Finish: Rust preventative
- Housing cast number: 5426
- Country of origin: Mexico
In the box
One remanufactured front left brake caliper with its mounting bracket, caliper slides, dust boots, bleeder screw and crush washers. Brake pads, anti-squeal shims, wear sensors, the bleeder screw cap, caliper and pad hardware and the bracket mounting bolts are not included; plan on new bolts, since the old ones may not be reusable.
Frequently Asked Questions
Is this front left caliper right for the 2008-2011 Nissan Versa?
Yes. Nugeon 99-00632A is a front left caliper for the 2008-2011 Nissan Versa, and the L4-1.6L is listed for 2009-2011.
Does this Nugeon caliper come with the bracket and brake pads?
Nugeon 99-00632A includes the mounting bracket, slides, dust boots, bleeder screw and crush washers. Pads, anti-squeal shims, wear sensors and the bracket mounting bolts are not included.
What size piston does this floating disc brake caliper have?
This front left caliper has a single steel piston, 54 mm (2.126 in) across. The inlet is a banjo bolt fitting with an M10-1.0 x 23.4 mm port thread.
Can I keep driving with a sticking front caliper?
No. A sticking or leaking caliper affects braking, so have it checked and replaced promptly rather than driving on it.
Is the Nugeon 99-00632A caliper remanufactured, and where is it made?
Yes, Nugeon 99-00632A is a remanufactured caliper with a cast iron casting, made in Mexico. Its housing cast number is 5426.
