Nugeon Disc Brake Caliper P/N:99-17927A
Nugeon 99-01323B front left brake caliper for the 2002-2018 Subaru Forester and other vehicles clamps the pads against the rotor to slow the wheel. This remanufactured Nugeon brake caliper is a floating-type unit for the front left wheel.
Pulling to one side under braking, brake fluid around the wheel or a pad worn more on one side can mean this disc brake caliper is worn, though a flexing brake hose or worn brake pads can be behind the same signs, so find the cause before replacing it.
This front left brake caliper is a direct-fit replacement for the 2002-2018 Subaru Forester, the 2002-2014 Subaru Outback and the 2008-2014 Subaru Impreza, and the front left position calls for one caliper. The listing is one side only; the front right is a separate part, and the front axle is normally done at the same time. Open the "Vehicles it fits" section to check your exact model and engine.
Fit and size
Build and materials
One brake caliper with its bracket, caliper slides, dust boots, bleeder screw and crush washers. Brake pads, anti-squeal shims, bracket mounting bolts, mounting bolts, caliper and pad hardware, wear sensors, the grease pack and the bleeder screw cap are not included; plan on new bolts, since the old ones may not be reusable.
Is this a Subaru Forester brake caliper for the 2002-2018 Subaru Forester?
Yes. Nugeon 99-01323B fits the 2002-2018 Subaru Forester on the front left side. For other models, open the "Vehicles it fits" section.
Is this an Impreza brake caliper for the 2008-2014 Subaru Impreza?
Yes. This front left brake caliper fits the 2008-2014 Subaru Impreza. The listing is one caliper; the front right is a separate part.
Does the Nugeon caliper come with its bracket?
Yes. Nugeon 99-01323B comes with the bracket, caliper slides, dust boots, bleeder screw and crush washers. Brake pads and bracket mounting bolts are not included.
What piston size and material does this front left brake caliper have?
This front left caliper has two steel pistons, each 43 mm in diameter, in a floating design with a cast iron housing.
What inlet fitting and bleeder thread does this brake caliper have?
The inlet is a banjo fitting with an M10-1.0 x 23.4 port thread, and the bleeder screw thread is M10-1.0. The bleeder screw is included; the bleeder screw cap is not.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.