Nugeon 99-01864B front right brake caliper for the 2017-2020 Hyundai Elantra squeezes the brake pads against the rotor to slow the wheel. This remanufactured disc brake caliper is a floating type.
A caliper that sticks, leaks or wears the pads unevenly can show up as pulling to one side, a dragging wheel or fluid around the dust boot. During a brake service with the engine off, look at the pad wear and at the boot for wetness; that helps show whether the caliper is the cause before you replace it.
This front right caliper is a direct-fit replacement for the 2017-2020 Hyundai Elantra. Calipers are sold one per listing, so the front left caliper on the same axle is a separate part and is normally replaced at the same time.
Fit and size
Build and materials
One remanufactured caliper with its mounting bracket, caliper slides, dust boots, caliper and pad hardware, bleeder screw and crush washers. This listing holds one caliper, and the front right of the 2017-2020 Hyundai Elantra takes one. Brake pads, anti-squeal shims, wear sensors, a bleeder screw cap, a grease pack and the bracket mounting bolts are not included, so plan on new bracket bolts.
Interchange / FMSI:
FMSI: D1912
Will this work as a 2017-2020 Hyundai Elantra brake caliper replacement for the L4-1.4L and L4-2.0L engines?
Yes. Nugeon 99-01864B is the front right caliper for the 2017-2020 Hyundai Elantra, including the L4-1.4L and L4-2.0L. The front left side is a separate part.
What comes with this Nugeon brake caliper?
Nugeon 99-01864B comes with its bracket, slides, dust boots, hardware, bleeder screw and crush washers. Pads, shims, wear sensors and bracket mounting bolts are not included.
Does the Nugeon caliper use a banjo bolt or a hose fitting?
This caliper has a banjo bolt inlet fitting with an M10-1.0 x 23.4 mm port thread. Crush washers are included.
Can a sticking caliper make the car pull to one side?
Yes, a caliper that sticks or drags can make a car pull toward one side or wear the pads unevenly. Have the brakes inspected promptly if you notice it.
How big is the piston in the Nugeon 99-01864B caliper?
Nugeon 99-01864B has one steel piston, 57 mm (2.244 in) in diameter, in a floating caliper with a cast iron body.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
