Nugeon 99-17287B front right brake caliper for the 1997-2003 Chevrolet Malibu and other vehicles squeezes the brake pads against the rotor to slow the wheel. This remanufactured Nugeon brake caliper is a floating unit with a single piston.
A sticking or leaking disc brake caliper can show up as pulling to one side under braking, uneven pad wear or brake fluid around the piston boot. Before you replace the caliper, rule out worn pads, a damaged brake hose and seized slides, since any of them can produce similar signs.
This front right brake caliper is a direct-fit replacement for the 1997-2003 Chevrolet Malibu, the 2004-2005 Chevrolet Classic and the 1999-2005 Pontiac Grand Am. Each front wheel takes one caliper, and this listing is the right side only; the front left is a separate part and is normally done at the same time. Open the "Vehicles it fits" section to check your exact model and engine.
Fit and size
Build and materials
One remanufactured brake caliper with its bracket, caliper slides, dust boots, caliper and pad hardware, bleeder screw with cap and crush washer. Brake pads, anti-squeal shims, wear sensors and mounting bolts are not included; plan on new bolts rather than reusing the old ones.
Interchange / FMSI:
FMSI: D752
Is this Chevy Malibu brake caliper the right one for the front right of a 1997-2003 Chevrolet Malibu?
Yes. Nugeon 99-17287B is the front right brake caliper for the 1997-2003 Chevrolet Malibu and also fits the 2004-2005 Chevrolet Classic. The front left side is a separate part.
Does this Grand Am brake caliper fit the front right of a 1999-2005 Pontiac Grand Am?
Yes. This front right brake caliper fits the 1999-2005 Pontiac Grand Am. Open the "Vehicles it fits" section to check your exact model and engine.
Does this Nugeon caliper come with the bracket and slides?
Yes. Nugeon 99-17287B comes with the bracket, caliper slides, dust boots, hardware and bleeder screw. Pads, shims, wear sensors and mounting bolts are not included.
What size are the piston and inlet thread on this remanufactured brake caliper?
The piston is a single aluminum piston, 60 mm (2.36 in) across. The inlet is a banjo bolt fitting with an M10-1.0 thread, and the bleeder screw is also M10-1.0.
How do I know if my front right brake caliper is sticking or leaking?
Pulling to one side when braking, uneven pad wear or fluid around the piston boot can point to a caliper problem. A shop can confirm the cause; have brake trouble checked promptly.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
