Nugeon 99-17388A front left brake caliper for the 2006-2009 Chevrolet Trailblazer and other vehicles is a remanufactured caliper that clamps the pads against the rotor. This Nugeon brake caliper, also called a disc brake caliper, comes with its bracket and slides.
A pull to one side when braking or fluid seeping near the wheel can mean a caliper is sticking or leaking. These signs alone do not prove the caliper is at fault, since a worn brake hose can cause a pull too. The front right caliper is a separate part, and both front calipers are normally replaced together.
It is listed for a wide range of Chevrolet, GMC, Isuzu and Buick models, including the 2006-2009 GMC Envoy and the 2006-2008 Isuzu Ascender. Open the "Vehicles it fits" section to check your exact model and engine.
Fit and size
Build and materials
One remanufactured front left brake caliper with its bracket, slides, dust boots, caliper and pad hardware, bleeder screw and cap, banjo bolt and crush washers. Brake pads, wear sensors, anti-squeal shims and bracket mounting bolts are not included, so plan on new bolts for the bracket. This listing is one caliper; the front left takes one, and the front right is ordered separately.
Interchange / FMSI:
FMSI: D1169
Will this Trailblazer caliper work on the front left of a 2006-2009 Chevrolet Trailblazer?
Yes. Nugeon 99-17388A is the front left caliper for the 2006-2009 Chevrolet Trailblazer. For another model, open the "Vehicles it fits" section.
What comes with this Nugeon caliper?
Nugeon 99-17388A includes the bracket, slides, dust boots, hardware, bleeder screw and cap, banjo bolt and crush washers. Brake pads, wear sensors and bracket mounting bolts are not included.
How big are the pistons in the Nugeon 99-17388A?
This caliper has two phenolic pistons, each 48 mm (1.89 in) in outside diameter.
How can I tell if a front left brake caliper is sticking?
Pads wearing unevenly, a torn dust boot or fluid around the piston can be signs, seen during a brake service. A shop can test the hydraulics.
What thread does the bleeder screw on this caliper use?
The included bleeder screw on the Nugeon 99-17388A is M10-1.0, and its banjo bolt inlet uses an M10 - 1.5 thread.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
