TERREPOWER 99P01731A rear right brake caliper for the 2011-2017 Toyota Camry and other vehicles clamps the pads against the rotor to slow the wheel. This caliper is remanufactured.
A rear wheel that drags, a pull to one side under braking or fluid around the caliper can mean a disc brake caliper is wearing out. None of these alone proves the caliper is at fault; a collapsed brake hose, for example, can pull the car the same way. This listing is one caliper for the rear right; the rear left is a separate part, and both sides are normally replaced together.
It fits a wide range of Toyota and Lexus models, and works for brake caliper replacement on the 2011-2017 Toyota Camry, the 2011-2018 Toyota Avalon and the 2013-2018 Lexus ES300h. Open the "Vehicles it fits" section to check your exact model and engine.
Fit and size
Build and materials
One remanufactured rear right brake caliper with its mounting bracket, caliper slides, dust boots, caliper and pad hardware, bleeder screw and crush washer. This listing holds one caliper, and the rear right takes one. Brake pads, wear sensors, anti-squeal shims, the bleeder screw cap and the bracket mounting bolts are not included; plan on new bracket bolts.
Interchange / FMSI:
FMSI: D1212
Is this the right 2011-2017 Toyota Camry caliper for the rear right wheel?
Yes, TERREPOWER 99P01731A is a rear right caliper listed for the 2011-2017 Toyota Camry; open the "Vehicles it fits" section to check your exact model and engine.
Does this Toyota Avalon brake caliper cover the 2011-2018 model years?
Yes. This rear right caliper is listed for the 2011-2018 Toyota Avalon, and the listing is one caliper.
Does this caliper come with the bracket and slides, or only the housing?
Yes, the bracket, caliper slides, dust boots, caliper and pad hardware, bleeder screw and crush washer are included. Pads, shims, wear sensors, bleeder cap and bracket bolts are not.
What size is the piston and the bleeder thread on TERREPOWER 99P01731A?
The single steel piston is 38.02 mm (1.5 in) across, and the bleeder screw is M7-1.0. The banjo inlet port is M10-1.0 x 23.4.
What can a failing rear brake caliper sound or smell like?
A burning smell from one rear wheel after driving, grinding or squealing from the rear brakes, or uneven pad wear found at a brake service can signal caliper trouble. A shop can test it; have brake problems looked at promptly.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
