PowerStop Disc Brake Caliper P/N:L4726
PowerStop L5299 rear left brake caliper for the 2011-2014 Ford Edge and other vehicles clamps the pads against the rotor to slow the wheel. It goes in place of the original stock caliper.
A disc brake caliper that sticks or leaks can show up as fluid around the dust boot, uneven pad wear or the car pulling to one side. Those signs can have other causes, so during a brake service with the wheel off, look for wetness at the boot and bleeder screw before deciding the caliper is the cause. If it is, this one replaces it.
It fits the 2011-2014 Ford Edge, which covers a 2013 Ford Edge brake caliper, and the 2011-2015 Lincoln MKX; each takes one on the rear left. This listing is one caliper for that side. The rear right is ordered separately, and the other caliper on that axle is normally replaced at the same time.
Fit and size
Build and materials
One brake caliper with caliper slides, new seals, dust boots and a bleeder screw. The mounting bracket, mounting bolts, brake pads and caliper grease are not included, and you should plan on new mounting bolts rather than reusing the old ones.
Product information is for general reference and may contain errors. See our Disclaimer.
Is PowerStop L5299 the rear caliper for a 2012 Ford Edge?
Yes, for the rear left. PowerStop L5299 fits the 2011-2014 Ford Edge, which includes 2012, and the 2011-2015 Lincoln MKX.
Which side does a 2013 Ford Edge rear caliper from this listing cover?
This is the rear left caliper for the 2011-2014 Ford Edge, so it covers 2013. The rear right is a separate part and is ordered on its own.
Do PowerStop brake calipers like this one come with a bracket and pads?
No. PowerStop L5299 comes with caliper slides, new seals, dust boots and a bleeder screw. The bracket, mounting bolts, pads and caliper grease are not included.
Does this caliper have a parking brake mechanism built in?
Yes. PowerStop L5299 is a floating caliper with one 42.82 mm steel piston and an integrated mechanical parking brake.
Does this caliper need any modifications to install?
No. This caliper is bolt-on ready, needs no modifications and goes in place of the original stock caliper. Plan on new mounting bolts, since they are not included.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.