Standard Ignition ALS910 rear right ABS wheel speed sensor for the 1992-1995 Mitsubishi Montero reports wheel rotation speed to the ABS. The control module uses that signal to track how fast the wheel is turning.
- Durable synthetic material made to withstand harsh operating conditions
- Tested on vehicles for correct integration with electronic safety systems
- Sealed connector for protection in harsh conditions
- Engineered for precision performance, durability and a long service life
Quick facts
- Part: Standard Ignition ALS910 ABS wheel speed sensor
- Fits: 1992-1995 Mitsubishi Montero
- Position: Rear right
- Condition: New
A lit ABS warning light, or an ABS that stops working, can mean a wheel speed sensor has failed. A damaged wiring harness, a dirty or damaged tone ring or a loose connector can be behind an ABS light too, so find out which one it is before you buy a sensor.
Fits
This sensor is a direct-fit replacement for the 1992-1995 Mitsubishi Montero. The 1992-1995 Mitsubishi Montero takes one sensor at the rear right. This listing is one sensor, and the rear left side is ordered separately.
Specifications
Fit and size
- Position: Rear right
- Quantity per vehicle: 1
- Mounting location: Wheel
- Harness length: 41 in (1041.4 mm)
Build and materials
- Connector: 1 rectangular, female
- Terminals: 2, male blade
- Condition: New
- Country of origin: Japan
In the box
One ABS wheel speed sensor. Mounting hardware is not included, so plan on new fasteners, since the old ones may not be reusable.
Installation notes
- Location grommets and wire clips are already on the harness for proper mounting and routing, which saves technicians time.
Interchange: ABS1020 · ABSC20448 · 530421 · MB668263
This part cross-references / interchanges with the following part numbers:
ABS1020, ABSC20448, 530421, MB668263, ALS910
Frequently Asked Questions
Does the Standard Ignition ALS910 fit the 1992-1995 Mitsubishi Montero?
Yes. The Standard Ignition ALS910 is a rear right ABS wheel speed sensor for the 1992-1995 Mitsubishi Montero, and that car takes one in this position.
Is mounting hardware included with this Standard Ignition ABS wheel speed sensor?
No. Mounting hardware is not included, so plan on new fasteners; the old ones may not be reusable. The grommets and wire clips come already on the harness.
How long is the harness on the ALS910 sensor?
The Standard Ignition ALS910 harness is 41 inches (1041.4 mm) long. It ends in a rectangular female connector with two male blade terminals.
Can a bad rear wheel speed sensor turn on the ABS light?
Yes. A failed wheel speed sensor can light the ABS warning light or stop the ABS from working. A shop can scan the system for codes.
Does the ALS910 replace the MB668263 sensor?
Yes. MB668263 is listed as an interchange number for the Standard Ignition ALS910 rear right sensor.
