Help keep throttle input true to your foot with the Standard Ignition Accelerator Pedal Sensor APS186, a new, complete pedal assembly that reports accelerator pedal position to the engine control module. It is listed for several models, among them the 2006 Volkswagen Jetta, 2010-2011 Volkswagen Golf and 2012-2013 Audi TT RS Quattro. See the Buyer's Guide tab for the full list.
- End-of-line tested: each sensor is checked against thousands of data points to validate its output voltages.
- OE-matched outputs: the sensor holds specific installed outputs to match OE, rather than using an adjustable consolidated design.
- Controlled production: Standard Ignition oversees manufacturing from componentry through the finished product, and quality control is maintained throughout the process.
- Complete pedal assembly: supplied with mounting bracket(s) for floor-mounted, bolt-on installation.
The assembly is made of polyamide 6 in a black finish. It has one rectangular, plug-in female connector with six male blade terminals. Hardware is not included, and no linkage is attached. Consult the vehicle service information for the correct fasteners and whether the originals may be reused. One is used per application.
A failing accelerator pedal sensor may cause delayed or erratic throttle response, reduced engine power, or a warning light. These symptoms can also come from other faults, so diagnose the cause before replacing parts. If the original pedal sensor is the cause, this new assembly replaces it.
Country of origin: Germany.
Interchange: 2-80085
280085 · PPS1085 · 1K1721503AD · 1K1721503N
This part cross-references / interchanges with the following part numbers:
PPS1085, 2-80085, APS186, 1K1721503AD, 1K1721503N
