Standard Ignition Accelerator Pedal Sensor P/N:APS244
$321.99
(You save)
Turn every press of the gas pedal into a precise electronic signal with the Standard Ignition Accelerator Pedal Sensor APS244. It installs as a direct-fit replacement for the 2004-2009 Cadillac SRX (All engines), providing the pedal-position input your electronic throttle control system depends on. In a drive-by-wire setup there is no mechanical throttle cable — the sensor reads how far and how fast you press the pedal and reports it to the engine control module, which then commands the electronic throttle body.
Pedal-position input: converts pedal travel into an electronic signal for the engine control module.
Electronic throttle control: supplies the input the ECM uses to command the drive-by-wire throttle body.
Signs it may need replacing: hesitation, surging, reduced power or limp mode, or a throttle/check-engine warning light — have the cause diagnosed, as these symptoms can have other sources.
Direct-fit: designed to replace the original sensor on the listed application.
If a failed accelerator pedal sensor is the cause of your throttle complaint, this unit replaces it. Manufacturer part number APS244.
Frequently Asked Questions
What does the accelerator pedal sensor do?
It reads how far and how fast you press the accelerator and sends that as an electronic signal to the engine control module, which commands the electronic (drive-by-wire) throttle body — there is no mechanical throttle cable.
Will this fit my vehicle?
It is a direct-fit replacement for the 2004-2009 Cadillac SRX (All engines). Check the Buyer's Guide tab to confirm it matches your vehicle.
What are signs this sensor may need replacing?
Hesitation, surging, reduced power or limp mode, and a throttle or check-engine warning light can be signs. These symptoms have other causes too, so diagnose the fault before replacing.
What is the manufacturer part number?
The manufacturer part number is APS244 from Standard Ignition.
Will replacing this fix my acceleration problem?
If a failed accelerator pedal sensor is the cause, this replaces it. Have the fault diagnosed first, since the same symptoms can come from wiring, the throttle body, or the ECM.
Write a Review
STANDARD MOTOR PRODUCTS
Standard Ignition Accelerator Pedal Sensor P/N:APS244
Accelerator Pedal SensorAs a global manufacturer, we maintain complete quality control throughout the manufacturing processDesigned to maintain specific installed outputs to match OE rather than...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
