Keep spark firing cleanly to every cylinder with the Standard Ignition Distributor Cap JH-102. It installs as a direct-fit replacement for the 1984-1989 Toyota Van and the 1988 Toyota Van Wagon — see the "Vehicles it fits" section for engine-level fitment. The distributor cap routes high-voltage current from the ignition coil to each spark-plug wire in firing order; a cracked, carbon-tracked, or corroded cap can cause misfires, hard starting, and rough running, and if a worn cap is the cause, this replaces it.
Backed by decades of ignition research and development for dependable performance.
Interchange: 10-0172
100172 · C642 · JA984 · EP720 · 12336254 · EP720SB · 4883 · JH102T · 1910171010
This part cross-references / interchanges with the following part numbers:
What does a distributor cap do?
It routes high-voltage current from the ignition coil to each spark-plug wire in the correct firing order, so every cylinder fires.
What vehicles does the JH-102 fit?
It is a direct-fit replacement for the 1984-1989 Toyota Van and the 1988 Toyota Van Wagon. Check the "Vehicles it fits" section to confirm your vehicle.
What is the cap made of?
It is molded from high dielectric-strength, glass/mineral-reinforced polyester resin for less carbon tracking and greater resistance to electrical breakdown.
What are signs the distributor cap may need replacing?
Misfires, hard starting, and rough running can point to a cracked, carbon-tracked, or corroded cap. Diagnose the cause before replacing.
Does it have brass terminals?
It uses solid brass terminals where available, which make better connections with greater resistance to electrical pitting and corrosion.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
