Send clean, reliable spark to every cylinder with the Standard Ignition Distributor Cap JH-140. It drops in as a direct-fit replacement for the 1990 Mitsubishi Eclipse (L4-1.8L) and the 1990 Plymouth Laser (L4-1.8L and L4-2.0L), covering the high-voltage output of the distributor and routing it from the rotor out to each spark plug wire terminal.
Cap material: molded from glass/mineral-reinforced polyester resin with high dielectric strength for less carbon tracking and greater resistance to electrical breakdown.
Terminals: four terminals with aluminum contact terminals for the connection to the plug wires.
Mounting: screw-type mount; mounting screws and installation instructions are included.
Details: black finish, vented, with a vertical tower position.
A distributor cap can develop cracks, carbon tracking, or corroded terminals over time, which may show up as misfires, rough running, or hard starting; if a worn cap is the cause, this replaces it. Diagnose the underlying condition before replacing. This listing is for the cap only — an ignition rotor, spark plug wires, and gaskets are not included. Country of origin: Japan.
Manufacturer part number JH-140 (also JH140). Available only while supplies last.
This part cross-references / interchanges with the following part numbers:
C717, MD611787, CAPB10575, CR920, EP857, 19017008
Frequently Asked Questions
What does this distributor cap do?
It covers the distributor and routes high-voltage spark from the rotor out through its terminals to each spark plug wire, so every cylinder can fire.
Which vehicles does the JH-140 fit?
It is a direct-fit replacement for the 1990 Mitsubishi Eclipse (L4-1.8L) and the 1990 Plymouth Laser (L4-1.8L and L4-2.0L). See the Buyer's Guide tab to confirm your vehicle.
Does it include a rotor, spark plug wires, or gaskets?
No. This listing is for the distributor cap only; an ignition rotor, spark plug wires, and gaskets are not included. Mounting screws and installation instructions are included.
How is the cap mounted?
It uses a screw-type mount, and the mounting screws are included. Follow the included instructions and the vehicle service procedure during installation.
What are signs my distributor cap may need replacing?
Cracks, carbon tracking, or corroded terminals can appear over time and may cause misfires, rough running, or hard starting. Diagnose the cause before replacing.
Distributor CapAs a global manufacturer of original equipment ignition products, we maintain complete quality control throughout the manufacturing process from componentry to finished...
Distributor CapAs a global manufacturer of original equipment ignition products, we maintain complete quality control throughout the manufacturing process from componentry to finished...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
