Get spark energy to every plug wire through a fresh cap with the Standard Ignition Distributor Cap JH-200. It is a direct-fit replacement for many vehicles, among them the 2008-2013 Nissan Urvan, 1992 Plymouth Colt and 1992-1993 Eagle Summit. See the "Vehicles it fits" section for the full list and engine details.
The distributor cap covers the distributor and carries spark energy from the spinning rotor to the terminals that feed each spark plug wire. If a cracked, carbon-tracked or corroded cap is behind your misfire or hard starting, this cap replaces it.
- Quality control from start to finish: Standard Ignition is a global manufacturer of original equipment ignition products and controls quality at every step, from components to the finished part.
- Reinforced cap material: Standard Ignition makes its distributor caps from high dielectric strength, glass/mineral reinforced polyester resin. The material is designed to reduce carbon tracking and to better resist electrical breakdown.
- RFI resistors where specified: These are intended to cut radio static and help guard against voltage spikes that could damage the ECU.
- Solid brass terminals where available: Brass terminals are designed to make a better connection and to better resist electrical pitting and corrosion.
Signs this part may need replacing: engine misfires, hard starting, rough running, visible cracks, carbon tracks, or corroded or burned terminals.
Interchange: MD618364 · C745 · JD948 · EP335 · 19017076 · B54118V00 · EP335SB
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
MD618364, C745, JD948, EP335, 19017076, B54118V00, EP335SB, JH-200
Frequently Asked Questions
What vehicles does the Standard Ignition JH-200 distributor cap fit?
It is listed for many vehicles, among them the 2008-2013 Nissan Urvan, 1992 Plymouth Colt and 1992-1993 Eagle Summit. See the "Vehicles it fits" section for the full list and engine details.
What does a distributor cap do?
It covers the distributor and routes spark energy from the rotor to the terminals that feed each spark plug wire. It also helps keep dirt and moisture away from the contacts inside.
What material is the cap made of?
Standard Ignition makes its distributor caps from high dielectric strength, glass/mineral reinforced polyester resin. The material is designed to reduce carbon tracking and resist electrical breakdown.
What are signs a distributor cap may need replacing?
Common signs are misfires, hard starting, rough running, cracks, carbon tracks and corroded terminals. Other ignition parts can cause the same symptoms, so diagnose the cause before replacing anything.
Which part numbers does the JH-200 cross-reference?
It cross-references MD618364, C745, JD948, EP335, 19017076, B54118V00 and EP335SB.
